Quantcast
Jump to content


2006 Cub Cadet volunteer Transmission Issue

bad knees

By bad knees
in Cub Cadet UTV SxS Forum

 Share

Recommended Posts

  • Alex changed the title to 2006 Cub Cadet volunteer Transmission Issue
Travis Grand Master

Travis

Posted
Posted

It could even be a sticking brake pad/shoe.

 

I believe those units are CVT belt driven, it could be a stick drive or driven centrifugal pulley. The pulley's may need lubed... which you aren't "supposed to" but if it's them sticking it can not hurt.  see if you can remove the belt cover, and with the machine in Neutral, give it some gas and check the movement of the pulleys the moveable sheave on them should move in and out smoothly with more or less RPM.

i believe i have the correct parts diagram, with the twin cylinder engine?

https://www.partstree.com/models/volunteer-46b-37ac46bd710-cub-cadet-4x4-utility-vehicle/engine-transmission-accessories-3/

 

 

 

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Tim n Deb
      2015 Massimo stalled and wont start. oil, new plug, getting gas verified. cranks but does not start
      By Tim n Deb
      Riding out today it acted like it ran out of gas,  stalled and died and would not start.   Towed back to house,  New  plug added this past month,  plenty of oil, getting plenty of gas, battery cranks good.   Trys to kick in and starts but doesnt.   Two days prior while sitting at a idle it died.  Added gas and it started did my ranch chores with it.  But just now it stalled out cranks but will not start.   Tried to find if fault codes came up on the clock like manual says but not sure I am doing that right.  Any and all help apprecated.  Thank you
    • Gerald Dillman
      2008 Joyner trooper transmission parts
      By Gerald Dillman
      Looking for a output shaft for a Joyner trooper t2. Went to move the buggy after sitting all winter and it appears the out put shaft that drives the rear wheels broke off inside the transmission so looking for the shaft or a complete transmission if someone has one
    • Tom Gorski
      2014 Cub Cadet Volunteer Oil Change
      By Tom Gorski
      Just bought a 2014 Volunteer. Can anyone tell me what parts have to come off to change the oil and filter. I can see them but I can't figure out how to access them. Thank You
    • tuell
      Transmission will not engage
      By tuell
      Hi everyone I have a 2016 hisun vector 550 with 1320 miles on it I recently replaced the clutch the bell the belt the one way bearing basically everything inside the primary and drove approximately one mile my side by side just stopped pulling... no noise no smoke nothing the belt is still good but it's like the transmission will not engage in any gear any help would be greatly appreciated.... I have lifted the rear end and started the side to side put it in gear Wheels do not move but you can turn them by hand
    • Clayton Walker
      Im New here but just got my Uforce Fitted for Hunting Season
      By Clayton Walker

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...