Quantcast
Jump to content

2020 Coleman 550 -No electrical activity under 50 degrees.


dwall662

Recommended Posts

My  problem is that when the temperature dips under 50 degrees, my Coleman 550 acts like the battery is dead and no electrical activity at all. The battery is at full charge. It only has 15 hours on it and the same thing happened last winter. Above 50 degrees, starts every time.  Very frustrating needless to say.  Anyone else experience this problem.  I bought it at Tractor supply and they are not a service center and don't know who works on them in the area.

Link to comment
Share on other sites

  • Same problem on my 2015 Sector 550. Full charge in battery.  No dash lights, no horn, no start, no nothing. I thoroughly cleaned every connection at the battery. The bat compartment looked new when I was done. SAME problem. NO change.
  • So I used a known GOOD fuse/relay unit. Same problem. NO change.
  • I even attempted a jump start from a running vehicle. Same problem. No change.
  • So I took it to a real Hisun mechanic who replaced the battery and it started right up. (I couldve sworn I did a LOAD test on my battery. I must've been wrong.
  • I NOW keep the UTV S/S on a trickle starter each time I park it.

This unit only had 300 miles on it when I bought it from a friend who didn't use it much. I'm learning as I go. Good luck.

  • Like 1
Link to comment
Share on other sites

  • 1 month later...

Well thanks all for the advice---I put a  brand new battery in and still the same problem. The weather has gotten warmer and it will start above 50 degree's every time. Last weekend it drop into the 20's and it would not even get the dash to lights to come on . 2 days later, dash lights up and it started. Guess what temperature it was?  52 degrees. Craziest thing anyone has ever seen.  

Link to comment
Share on other sites

I am a retired Diesel Mec.  First thing I did when I got my 2016 mule home was to take apart every connection I could find and added Dielectric Grease.  I took every ground I could find, cleaned the metal surface, coated with dielectric grease.  I have taken the mule through 3 ft of water with no issues.  Recommendation is check all powers and grounds.  Alot of issues come from bad grounds.  Also, check the power connection to the fuse block for corrosion and tightness.  Check the connection to the ignition switch for corrosion and the connections for tightness.  This is always my starting point with these UTV/ATV's.

Link to comment
Share on other sites

  • 8 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By todd93
      Hi, all! I. I'm new to the board, hoping someone could help me out! I have a 2020 Hisun Sector 550C that I bought new in 2021. Today, I took some stuff next door to my parents. When I went to leave, I turned on the key, heard the solenoid click, but no lights, no guage activity, no fuel pump, and no starter. 
       
      The battery is good, I checked all the fuses, they are good. Not sure if the relays are good, or even what to look for there. Is it possible that it's maybe a wire? 
      I'm really stumped on this one! Any help would be deeply appreciated! Attached is a pic of the fuse box layout. 
       
      Thanks! 
      Todd 
    • By wnc woods
      Is it possible to add a low gear to the Coleman ut400? If so please help. Ty
    • By buckrub
      Hey guys! Newbie here. I'm an old man who's better with plowing a mule (4-legged kind) than these newfangled beasts. I, and a friend of mine, just bought new Coleman sxs and are having to finish the assembly. I've been reading on this site and I'm falling on the mercy of you experts. The only way I'm an expert is that an "ex" is a has been, and a spurt is a drip under pressure. LOL First off, the 2 buggies have no ignition switches. They seem to mount on the dash, not the opening in the steering wheel shaft cover, so we ordered new ones that are supposed to fit. They are 8 inches long, and have a 4-wired white plugin which is slightly rectangled when looking at the end of the plug. The trouble is there's nothing to plug into. There is a three-wire grey plug close enough to reach the four-wire plug, but of course, they are not compatible. 
      Secondly, the blinker, light, ect. unit on steering wheel just spins around when touched. I see no way in heaven or earth to secure it. I've looked at a diagram on the Powersports site, but can't detect how it mounted. Fellows I'd be so grateful for any help with this. Me and my mule will even plow your garden for free, for your help. LOL 
       
    • By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!
    • By Onebad54
      Has anyone solved the 750 Hisun Sector shifter problem?
×
×
  • Create New...