Quantcast
Jump to content


Massimo Buck 450 2022 Winch Remote Control

Bill Hughes

By Bill Hughes
in Massimo UTV SxS Forum

 Share

Recommended Posts

Bill Hughes Enthusiast

Bill Hughes

Posted
Posted
Buck 450 wireless winch remote control. Opened up the winch relay control box. AS some reported for other models, there's a factory wireless receiver in there, but they won't sell you a remote for it. Easy to replace since it's on quick connects. Disconnect the factory receiver and replace. Amazon has a bunch of very similar units. I replaced it with this ($20) . took 15 minutes. Wiring is the same.
This photo is the inside of the winch relay control box located in the passenger side front wheel well.
No photo description available.
 
 
Two screws hold the relay box to the frame. Remove those and just turn the box around. 6 small screws on the back, Open it up, remove the factory receiver. I clipped off the screw tabs on the new receiver just to make it easier to slide into the case. Clipped the new receiver wires and added quick connect lugs.
 
  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Tim n Deb
      2015 Massimo stalled and wont start. oil, new plug, getting gas verified. cranks but does not start
      By Tim n Deb
      Riding out today it acted like it ran out of gas,  stalled and died and would not start.   Towed back to house,  New  plug added this past month,  plenty of oil, getting plenty of gas, battery cranks good.   Trys to kick in and starts but doesnt.   Two days prior while sitting at a idle it died.  Added gas and it started did my ranch chores with it.  But just now it stalled out cranks but will not start.   Tried to find if fault codes came up on the clock like manual says but not sure I am doing that right.  Any and all help apprecated.  Thank you
    • Sando
      Massimo Buck 450 will not start
      By Sando
      2023 Massimo Buck ran for minute then died. Key on all power to dashboard but do not hear full pump turn on like previously. Also no fire at plug. ECU?
    • rdborra
      Bobcat 2200 dump bed relay pops fuse and stalls after warm
      By rdborra
      I had to remove the relay for the dump bed due to it popping the fuse for main key power. I have tried to find a short but nothing seems to out of normal. I also disconnected the dump motor and switch and still pops the fuse. Also, when the machine is warmed up i get about 5 to 10 of work out of before it stalls. Once I can get it to start again I have to use the choke to keep it running. 
    • strike250
      Free Massimo Buck 400 service manual
      By strike250
      I have the factory service manual available for the Buck 400. Just send me a message with your email and I'll get it to you. Although there is no charge for this, it would be great if  you would visit my website where you could donate any amount to help do things like this with others who need it. Again, there is no charge for this manual, and no obligation to donate. But if you did, I would thank you for sure. Have fun on the trails. www.warriorsoffroad.com
       
      Matt

    • carl baney
      2021 Tracker 800sx DUMP BOX
      By carl baney
      have a 2021 tracker 800sx noticed locks on box when u fasten both sides of box are cracked anyone else have this probl

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...