Leaderboard

I'm wondering if someone can help me with an issue that has brought me to my wits end with my 2008 Hisun UTV 500. This thing was running fine and it sputtered then died. I pulled the spark plug and there was no spark so I replaced the ignition coil, no luck. Then replaced the stator-magneto-pick up coil, still nothing. I then replaced the cdi with still no luck. I removed the wiring harness and went through it to look for any obvious issues and found only one, a capacitor at the rectifier connection which I replace as well with no luck. The spark plug was replaced today and same shit, nothing. The plug I have connected to an alligator clip and grounded to the engine. I know it has to be something simple but my simple mind cannot seem to figure it out. Any suggestions would help.

Thank you. Our flashers work just like new now .. once we replaced this flasher!

Silverbullet Its mounted to the battery box .Its 2 x 4 "long.Some times owner just let it lay on the floor.Be vary careful with the wiring It has a lot of plugs down there. Rich

Has anyone tried to open the two videos posted? I've tried to open both....but I just get a blank screen thanks John

Hi i have read your stories and i own a motobishi raptorex 2011 800cc (hisun strike differently named) Hisun brand its part of the ghanzou automotive that own cfmoto,odess, hisun and few other brand of utv. Check at cfmoto dealer for part. All driveline parts will fit on the hisun. It is what i have do on mine before it break and i never touched it again. The problem whit the yoke on hisun utv is a cast material and machining issue. If you are good in mechanic you can flip the coin and do brp, shaft and yoke upgrade (just need a good drive shaft shop to make new drive shaft