Hisun Sector 750 lift kit
-
Similar Topics
-
By cliffyk
I had mentioned in a previous post that I had removed the front anti-roll bar from my 2020 Outfitter 400; I ran that way for a month or so without noticing any downside however recently I installed a 'suicide knob" (see below) to assist my Parkinson's disease affected arms in turning the beast--but after doing so i found that in the quicker, tighter turns the knob permitted the vehicle would nosedive a bit, dig in, and plow on hard surfaces--not scary, but quite noticeably.
So I put the bar back on. Then today I got about 1-1/2 miles down the main road on the nearby power lines, turned around and came home to take it off--with the bar on, at 25 to 30 MPH, the front-end of the beast jumped like rabbit at each bump in either wheel rut., for a nearly brutal and quite uncomfortable ride. the bar (20 mm solid steel) is far too robust for the weight of the vehicle. The front bar on my 3900 lb. Infinity M37 is 30 mm...
suicide knob--for you younger folks:
-
By John Gailey
View File Hisun Sector/Vector E1 HS5DUTV-2 Owner/Operator Manual
Operator's manual for Hisun Sector/Vector E1 electric UTV
HS5DUTV-2 Owner/Operator Manual
Submitter John Gailey Submitted 03/13/2023 Category Hisun
-
By RVTVNUT
We have a 2019 RK750 that I have been having problems with slow cranking issues since bought the machine..I've replaced the battery so it's not a voltage issue..I have experience with diagnostic being a diesel mechanic for 30yrs..Voltage drops from 13.30 to under 8.00 under starting load..Have a new starter already ordered but a little unsure if there's anything I'm missing on installing besides just the 2 bolts and starting lead wire..Is this just unbolt and replace or is there anything else like gears inside the case I will have to deal with..Dealers and hisun don't like any info being available so you use the dealer (which are very limited) ..Thanks for any help
-
By bgjojo04
Does anyone know what 2 inch lift kit would work on this sxs ? Or have installed one that works.
-
By Byron Johnson
Does anyone have a had time starting there utv.
I have a T-Boss 750 and I have had to put 2 starters in and put heavier wire to the starter but it still has a problem starting. it will turn over and than die before it wil turn over again. could it be that there is to much compression that might cause this problem
Thank you
-
-
-
Similar Tagged Content
-
- 0 replies
- 456 views
-
- 0 replies
- 821 views
-
- 0 comments
- 677 views
-
- 7 replies
- 2,332 views
-
- 7 replies
- 6,707 views
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.