-
Similar Topics
-
By Thumpalong
Hello I have a 08 hisun 700 and apparently that year they had frost plugs in the cylinder head and were know to corrode and start leaking. Well I have one and I have tried the jb weld to seal the leak but no go. Is there anyone that can tell me the mesurements of the cylinder frost plug hole. Apparently you cannot buy them not available, so I'll try to source something if I can get the mesurements. Thanks Thumpalong
-
By Rey Ximenes
OK, here's the mystery of the day. I was using the UTV the other day and the idiot light came on that said it was overheating. I immediately shut down and checked the coolant. No coolant! I refilled the overflow reservoir and the radiator and all was fine. 2 days later the light is on again. I rechecked the radiator and it was again empty? Bone dry? Now, here's the weird part, There is no coolant anywhere on the floor below the vehicle. I can't even see any on the frame. I have it up on the lift and am getting ready to start tearing into the bottom "skid plate" to see if the leak is in the hoses there. Any suggestions as to where to start? I have yet to begin and I am already baffled!
-
By cliffyk
I had mentioned in a previous post that I had removed the front anti-roll bar from my 2020 Outfitter 400; I ran that way for a month or so without noticing any downside however recently I installed a 'suicide knob" (see below) to assist my Parkinson's disease affected arms in turning the beast--but after doing so i found that in the quicker, tighter turns the knob permitted the vehicle would nosedive a bit, dig in, and plow on hard surfaces--not scary, but quite noticeably.
So I put the bar back on. Then today I got about 1-1/2 miles down the main road on the nearby power lines, turned around and came home to take it off--with the bar on, at 25 to 30 MPH, the front-end of the beast jumped like rabbit at each bump in either wheel rut., for a nearly brutal and quite uncomfortable ride. the bar (20 mm solid steel) is far too robust for the weight of the vehicle. The front bar on my 3900 lb. Infinity M37 is 30 mm...
suicide knob--for you younger folks:
-
-
By Alex
View File 2016-20 Honda Pioneer 1000 Service Manual
2016-20 Honda Pioneer 1000 Service Manual
SXS100M
SXS100M3P
SXS100M3LE
SXS100M5D
SXS100M5LE
Submitter Alex Submitted 03/05/2023 Category Honda
-
-
-
Similar Tagged Content
-
- 0 comments
- 80 views
-
- 7 replies
- 3,636 views
-
- 4 replies
- 1,218 views
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.