Quantcast
Jump to content

Paiute3

Heavy Heavy Duty Joyner Clutch and Disk Upgrade Stage1 and 2

Recommended Posts



Be careful. Some of the clutch upgrades require machine work of the flywheel. I was so impressed with the condition of my original factory clutch when I changed it that I put the same back in. Very very little wear.

rocmoc n AZ/Mexico

Share this post


Link to post
Share on other sites

Has any one installed one of these heavier clutches? I have had my clutch hot enough that it quit hooking up until I let it cool off. I play in the rocks to much and have to ride the clutch alot.

Share this post


Link to post
Share on other sites

My neighbor is Arizona has a T-4 with an upgraded clutch. I've driven it a few times. Can't tell any difference between his and mine which is stock.

Happy Trails

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Seth Lambert
      Hi,
      I'm in the market for a hunting/ ice fishing utv. I've been looking at the normal group (Ranger, pioneer, defender, general, wolverine, etc.) of used units and came across a 2014 Joyner R2. It's got a full cab, heater and a winch.  Supposedly no mechanical issues. They're asking $7K. I've never heard of the brand and have been doing some internet research. It sounds like the older units had issues but the newer units since 2014 are better. The utv is exactly what I'd like to have but I'm just looking for advice from folks who know more about these units. Thanks for the help.
    • By Joel Neubecker
      I just bought a 2008 Prowler 650 H1.  Rode it about 20 miles and the belt absolutely exploded!  Long story short, while replacing the belt, I spread the secondary with the cover bolt and didn't take it out before I put the secondary back on.  I tried to remove the bolt after I tightened the nut and it snapped off still stuck in the spreader hole.  I have no idea what to do.  Any help or suggestions would help greatly.  Thanks.
    • By Alejandro Arguello
      I just went once to do some mudding and loved it.
      Looking around and the only utv for 4 i could find in my price range was a joyner.
      None of the people that were there had joyners. And when i asked why all they could say is that bc its chinese and not good.
      Well none of them have ever owned one so how could they tell its junk?
      So can anyone tell me if its worth buying a joyner or save more and buy a different utv?
      Thank you
    • By Tn. Renegade Rider
      Bought new in 2014 Renegade 1100.       Life got in the way and only put 80 miles on it up till now.  During that 5 year time the fuel would go bad and I would drain the tank and refill. Always used 100% gas [never ethanol].  It is garage kept and never spent a night outside.
      Now that I have time to use it, I am having issues.   It will start and run fine for about 10 minutes, and then it will start to miss and then eventually die. After letting it sit for about 30 minutes is will start back up, and start doing the same thing again.
      I have put new plugs in it and have replaced the fuel filter. 
      Any suggestions on what this problem could be?
      Thanks in advance for your help,
      Steve B.
    • By CYJSP2009
      Hi All, 
      Joyner 650 commando rear differentail and its parts are avaialbe now. 
      Qty is limited. Any one who is in need please contact [email protected] 
      Thanks 
       





×
×
  • Create New...