-
Popular Now
-
-
Similar Topics
-
By Pajer
Does anyone know where the winch fuse is located on a 2021 ut400? I’ve been working on the solenoid because the winch will only go in one direction..
Either in or out depending if I reverse the leads on the solenoid. Now I have no power to the solenoid and it appears I blew a fuse. Winch is supposed to have a 30 amp fuse.
i checked all the fuses in the fuse box near the battery and the 30amp fuse hanging in the compartment. Everything is good there.
but I can’t locate any other fuses. Any help would be appreciated.
-
By johnney
it started bogging down when under acceleration. so first i replaced the carbeurator, no change. now i replaced the wet assembly and no change. what am i missing. is there a sensor or something im missing. HELP, HELP, HELP
-
By Ztmartin96
I’m working on a 2011 Bobcat 3400. At around 20mph it bogs down and loses all power. If you let off the gas and let it slow down, it’ll go again until 20mph.
It use to not do this. Use to run 30mph+ no problem. I’ve replaced the fuel injector, fuel pump, spark plug, and air filter. Cleaned the throttle body, the fuel lines, and cleaned the fuel tank out.
What am I missing? Any help would be greatly appreciated.
-
By Mark Armstrong
Hi,
I am in need of a wiring diagram for a 2011 gray wolf 500. I have searched to no end and cannot find one. Nothing comes on when I turn on the ignition switch. Battery is new and the winch works. I did find a blown 30a fuse on the starter relay and thought for sure I found the problem but still nothing comes on after replacing the fuse and the fuse hasn't blown again since replacing it, I have checked every fuse I can find. Bottom line is I am lost and in the blind without a wiring diagram. Any help is greatly appreciated! TIA!!
-
By Quentin Walker
Hi all. I am in dire need of some help. Through our university, we are competing in the Baja SAE competition. It is a collegiate engineering design competition to design and manufacture an off road dune buddy.
To cut to the chase, we were donated a 2011 Hisun HS 700 UTV, and we are using suspension and drivetrain parts off of it in our design. I am in the process of ordering new parts, but I am coming to a standstill.
Does anyone have any experience ordering parts for these machine?
From what I have found online, these machine were sold by Tractor Supply, along with a few different brands that share the same parts (Supermach, Coleman, Massimo, etc.)
Any help is appreciated. Thanks in advance.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.