We Need More "Likes" on Facebook!
-
Similar Topics
-
By Jon Spruill
Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
-
By Psparr
Coleman ut700. (Hisun).
leaking from the output shaft from engine. Parts diagram shows the nut, metal washer, then the flange coupler. However when I took it apart, there was what was left of a plastic bushing. Assuming it seals between the washer and splines shaft. But the parts diagram doesn’t show this plastic part. What gives? Thanks in advance.
-
By Working hard to hardly work
So I got this Massimo 500 a couple months ago and ive been trying to figure out what goes here. I cant find any diagrams or anything to help.
-
By paraord
Hey guys,
While installing the High lifter lift kit in my 2015 Mule 4010 I nicked the piston, strut rod, the shiney rod in the middle that I cant remember the name (no coffee yet this morning). I knew the nick was deep enough to eventually tear up the seal and she'd let loose. Well 3 months or so down the road here we are, its blown out.
My question is how do I know which strut I have? I see 2 listed in the exploded 45023-1006 and the 45023-7503. The difference is the spring rate or K value. Seeing as I have high lifter springs does it matter the K value? And if that's the case can I use any of the 45023 prefix struts from various other models?
Thanks all,
Andrew
-
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.