Quantcast
Jump to content


Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Topics

    • By malenurse13
      We've got the old Kohler motor out and the new Predator 459cc in!
      But before we put the motor in there. I took some pics of the old wires. I'm hoping y'all can help me figure out what all these are for and what we need to keep. 
      There are a lot of inline fuses. And all the labels we can read say "12v pos" or "regulator/rectifier."
      Main thing I'm looking for:
      1. Wires to connect the stock ignition to the starter on the new motor
      2. Wires for the headlights
      If anyone can help me identify what all these wires are for, I'd appreciate the help!

    • By gridlock
      I purchased my Hisun Sector E1 three years ago.  I think there are a few hundred miles on it, and lots of charging.  A couple of weeks ago it started sputtering a lot, not charging fully, and discharging fast.  I took a look at the battery compartment under the seat, and noticed this (picture below) which certainly explains a lot!
      Questions:
      1) Where are those disconnected and corroded wires suppose to go?
      2) I took out half the batteries thinking they might be in bad shape, but measured 5.4v on all of them, which doesn't seem bad considering they probably haven't been charging for a while.  Do you think I should replace them all at this point (after three years), or just fix the wiring (although I'm not sure what caused that to happen), or they may still be perfectly good?  I certainly don't want to put them all back (as I mentioned I removed four out of the eight only to have to remove them again if they are not in great shape.
      3) If I do replace them, I noticed there are much cheaper options on Amazon for AGM 6v batteries (Weize GC2 is one option) that are the same size and slightly higher AH than the original Discovery ones.  Any thoughts about going with these?  I know a lot of folks replaced the AGM with lithuim, but not sure I want to go through the hassle of also replacing the onboard charger, etc.  I fine with AGM and getting a few years out of them.
      Thanks!

    • By Bryan83c
      Need input on compatible clutch sets I can upgrade joyner 1100cc 2018 sand viper with.    Something autozone might carry  and what cars are these chery motors most compatibility with
    • By nods
      Less than 40 miles can barely start. Dealer is working with Hisun on a number of other issues on this UTV. Can not get clear info on the meaning of these E codes this is getting. Anybody have some clear info for me?
    • By Hector
      Hello all,
      I got a 2009 T2 and found the wiring on the fuse box that holds the fuel pump and ecu power had a short and was not wired correctly. I wanted to see if anyone could provide a picture of the back of theirs so i can see how it is wired 
      thank you
×
×
  • Create New...