Quantcast
Jump to content


Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

Posted

I am always excited to see more Joyner vendors especially in the aftermarket department Mo Powa! Your story is interesting to me. Aren't you a fairly new Joyner guy? And here you are offering aftermarket parts. Very cool. The intake is a great start.

Posted

i am fairly new but after seeing the capabilities of the trooper i was blown away! they have a bad wrap and for good reason, but with a few good minds can be one of the best offroad utv's ever built i believe!! and thank you all for the kind words and i am sure you guys will not be let down!

Thanks a million!!

Josh West

Posted

7a4a4yqy.jpgegu8uqen.jpg

I just went mudding for about 8 miles in clay and black soft slick mud the intake helped the engine rev up real good to clean the tires. I could go all way up to 3rd gear and have engine revving to spin heavy thick chunks out.

I can't wait for my new tires and turbo kit and hopefully soon cams and fuel programmer and shocks

Sent from my DROID RAZR using Tapatalk 2

  • 4 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Niko
      Need new pistons, rings, connecting rods and bearings for rebuild, dealer cannot get .5mm over pistons.  Looking for best aftermarket supplier.  Suggestions are appreciated.  Thank you
    • By OBL
      program will open in old Bud program only/ but will not go in BUDS 2 to let use program ECU problem working on has new engine/ new fuel pump/ injectors/ lines/ sensors/ crank sensor maps/ and new throttle body and injectors. machine starts runs a minute dies/ on 3 rd  try says key not recognized /we put other key in and same thing happens/wait 10 minutes, you can go again/ is there a back door in the program/ also might mention unplug temp sensor and map sensor , it will run a few minutes longer / then die again.
    • By mike28honda
      I have an Axis 500 and never had any problems until now,it cuts out 
      at around half throttle. I changed the TPS with no difference, acts like the seatbelts aren't set but can get up to around 15 mph as long as I don't give it too much gas, thanks for any advice 
    • By Kakha
      Greetings to the forum participants, my Kubota RTV 400 has stopped starting. More precisely, it works intermittently. Please advise what could be the cause.
×
×
  • Create New...