Quantcast
Jump to content


Recommended Posts

Posted

Anyone have one of the new 4-Door 2013 models and have some input on how well they perform? I am looking for my first UTV and like the looks of the unit. It seems Odes are getting better and may be good machine for 2013. I will be using the UTV around the farm, joy riding and having fun with the grandchildren. I will not be a racer or hard mud rider. Any input will be appreciated.

Posted

My friend I'd a dealer I have not seen the 4 seater but I have seen two of the 2 seaters and we have been out twice with one first time was kinda safe carefull it's quick lots accessories comfortable and balanced well. The stock factory model I thought was a little sluggish up hill soft Terian since then he's done exhaust tuned it and changed belt and clutches BIG difference

Posted

Thanks for the information, Charley. Do you add the EPI cluth and belt.? I see they offer these as accessories. If ordered with the heavier cluth and belts, do you know if they come installed? I have an Odes dealer near me, but so far he hasn't had one the Dominators for me to look at. Thanks again for the input.

Posted

My friends did not come installed he ordered the parts and now being a dealer he installed them! Wasn't to hard to do I havnt seen the 4 seater but the two seater is impressive I ride a modified trooper the odes is quicker off the line but I get him in the end the only thing he and I both dislike is the roof is cheap thin plastic there's no protection for roof lights and part of the rear skid pan is plastic but other than that very good

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By AaronD1982
      Next problem with charging system to tackle, any help would be appreciated.
      New starter solenoid....check
      New Voltage Regulator...check.
      Dynamic test to Stator.....bang...pulling like 2 Volts AC
      Problem: Without pulling the part out and stranding the vehicle at the shop forever.... I am trying to find the correct stator or at least one that might not be exact for the Massimo Buck 400S, but fit and connect and do the job if that makes sense.... if anyone has any ideas, please shoot them my way.
    • By rdc
      I posted this before , but I had the year wrong. The part I need is for a 2014, I don't know what all years will work, but I need the 2 bearing style with the spacer in the middle. It looks like this pic. If anyone has one I'll buy it rite away. my email is [email protected]. Thanks, RC

    • By rdc
      Hope I posted this in the right place. Looking for the left side shaft carrier where the rear bearings go for an 1100cc sand viper, I understand an 800 cc carrier will also work. I need the old style two bearing with the spacer in the middle, the new style with just the one wide bearing wont work. If anybody has one I'll buy it right away. my email is [email protected]
    • By MilSurpYinzer
      I heard there's several off road festivals out that way. One or two post apocalyptic, the rest just rev and run. Anyone know a good one that offers camping? Any advice for out of state people like hauling, legality, and where to stay?
      Ideally me and the missus would be down for camping out and setting up shop somewhere nearby. That way we can just wake up, load up, and ride.
    • By AaronD1982
      I recently purchased a 2019 or 2020 (no manual) Massimo 400S Buck Series UTV.  It ran fine for a couple days but the low battery light was flashing while it drove.  It then died in the field one day and I was able to jump the battery and get it rolling enough to get back to the barn.  It started both times I turned the key for a couple days after and when driven died 10 minutes later in the driveway.  Even after jumping it had no juice, but with the key out of the ignition it kept trying to start, a quick look on the Google machine and it suggested starter solenoid or ignition switch was the culprit.  Fair enough, let's just order a replacement solenoid, right?  No way Jose....the pin connector on the UTV is a 2-pin white plastic connector and the part received is a 4 pin.  How do I swap that and make it work?  Can I even?  Where do I find correct parts in the future?
×
×
  • Create New...