Quantcast
Jump to content


2009 T2 loosing power

Hopper

By Hopper
in Joyner UTV SxS Forum

 Share

Recommended Posts

Hopper Newbie

Hopper

Posted
Posted

Hello everyone My username is Hopper I am new to this site and I was wondering if any of you could help me with a issue I had last ride.

I had just moved my radiator up to the back box and replaced my starter on a test run it was running really well than

all of a sudden it was like the key was shut off so I checked all the basic functions and could not get it to flash up.

When I got back to my shop I had a look at the fuel system and was producing 50 # and had fue up to the fuel rail

also checked coil for power and there was power at coil plug.

A riding buddy had a T2 there that was in good running condition and I was able to swap out a few parts off to test

On my T2 here is what I swapped out to check ECU unit, cam sensor,crank sensor, coil and had no luck getting it to

start up I also pulled the plugs and they were dry and had no spark.

I am not a mechanic but can figure most things out but this one has me confused if any of you have any input It would

be appreciated. I am impressed with alot of the topics and knowledge that I have seen on the topics great site!

Hopper

silverbullet Experienced

silverbullet

Posted
Posted

Silverbullet.

You need to check the wiring harness.We have some problems with wiring harness. The plugs the pins push out when you plug them together.Joyners don't like to go in deep water.Start the process 1Start with each wire and trace it ti the computer.And keep going till every wire is tested on the engine harness.At least you had some parts to test with.

Thanks Matt.

If you need any help call 9:00 Am to 5:00 Pm ca..time 928 344 2117

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Topics

    • Fmaxiron
      Honda Pioneer 1000-6 back windshield or screen.
      By Fmaxiron
      I just purchased a 2023 Honda Pioneer a couple of weeks ago and had the hard roof and a front Honda Pioneer windshield installed at the shop before taking ownership. As things are drying up here in NC, the grass and dust are beginning to fly right through the back of the cab while driving. I was wondering if anyone has any good recommendations on rear windshields, dust panels, or mesh screens to help stop this?
      Thanks a lot!
    • rdc
      Looking for a left rear shaft carrier (just the carrier) for a 2007 Joyner 1100 sand viper
      By rdc
      Hope I posted this in the right place. Looking for the left side shaft carrier where the rear bearings go for an 1100cc sand viper, I understand an 800 cc carrier will also work. I need the old style two bearing with the spacer in the middle, the new style with just the one wide bearing wont work. If anybody has one I'll buy it right away. my email is [email protected]
    • Garjess
      RTV 1140 Starter Relay
      By Garjess
      My rtv 1140 won't turn over.  I've jumped the neutral switch, and the brake switch, and checked the ignition switch. I'm not getting any power to the trigger wire on the starter solenoid.  It starts fine with the key on and putting power to the trigger wire on the solonoid.
      Does a 2010 RTV 1140 cpx have a starter relay? 
      Does anyone have a wiring diagram?
    • MilSurpYinzer
      New Mexico etc
      By MilSurpYinzer
      I heard there's several off road festivals out that way. One or two post apocalyptic, the rest just rev and run. Anyone know a good one that offers camping? Any advice for out of state people like hauling, legality, and where to stay?
      Ideally me and the missus would be down for camping out and setting up shop somewhere nearby. That way we can just wake up, load up, and ride.
    • Mitch13
      Coleman 400 wiring help
      By Mitch13
      2022 Coleman 400 with 13 hours on the engine and the mice got to it. Every wire coming out of the steering column in one cluster has been eaten through. I tried reconnecting matching wire colors to each other and I get the left turn signal and hazards to work, nothing else. If I play around a bit I can get the horn to honk or headlights to come on but only when I connect them to the brown wire. Obviously I don't know what I am doing here. Does anyone have a picture of how these wires are connected when they are under the hood on the drivers side coming from the steering column?
      Gray - seems to carry power
      Brown - left turn signal
      Green with purple stripe - hazards?
      Pink with red stripe - horn?
      Green - head lights?
      Yellow - head lights?
      Yellow with red stripe?
      Blue?
      Dark green?
      There is also a bundle hanging under the hood not connected to anything green with yellow strip, brown and blue?
      Other than that issue, I am about ready to sell this for parts if you interested let me know.
      Thanks

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...