Quantcast
Jump to content


Recommended Posts

Posted

How do you remove the seat bottom?  If it's like most bench seats, you just pull up on it to detach the fasteners, but I don't want to break anything if that's not correct.
I've pulled up on mine, but it's either holding tighter than I'm willing to pull without knowledge of what I'm dealing with, or that's not how it's attached.

Owners Manual doesn't mention how to remove the seat.  It only says "remove seat" in a few places.

Posted

Disregard my stupid question.  My dealer answered my email to them from last night.  Yes, you do pull up on it just a little harder than I was willing to pull up without knowing what was underneath.

My next stupid question...  How you you delete a post on here?  🙃

  • Like 1
  • 1 month later...
Posted

It’s not a stupid question as the pins that locate the seat can become stuck in the locating holes, especially if the rubber grommets become damaged. I’ve actually filed down the passenger side pin as it would never release without  having to apply excessive force.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Topics

    • By rdc
      Hope I posted this in the right place. Looking for the left side shaft carrier where the rear bearings go for an 1100cc sand viper, I understand an 800 cc carrier will also work. I need the old style two bearing with the spacer in the middle, the new style with just the one wide bearing wont work. If anybody has one I'll buy it right away. my email is [email protected]
    • By KMP
      We just bought our 1st side-by-side and wanted to get tips on maintenance items we should address immediately for our 2015 Arctic Cat Wildcat Sport 700 XT.  We are truly beginners and welcome any and all suggestions.  Thank you, we appreciate your help!
    • By Roadstar515
      Does anyone know of a bypass switch or controller. They make one for Polaris which installs into the harness that makes the ECU think it’s hooked up in normal position allowing vehicle to operate normally as if you are wearing seatbelt.
    • By JBF
      I bought a pair of Rough Country pod lights and it comes with a 3 pin plug(black, white and blue) I want to hook it up to a lit 5 pin rocker switch but I don’t have a clue what pins do I need to connect it to. I wired it to the keyed switch. Chat GPT as good as it might be does not know what I am asking. Any help would be greatly appreciated!
    • By Some random dude
      2015 Hisun 700 Utv
      the break pedal seems to not fully throw therefore it won’t engage the switch in order to start. 
      it throws enough to stop the UTV but not enough to engage the switch. 
      I used it this morning, started fine, did some work then shut it off to talk to a neighbour and it wouldn’t start after. I can hear the injectors working but the break pedal doesn’t seem to go all the way down. 
×
×
  • Create New...