Quantcast
Jump to content

2013 KRF750S Teryx will not run.

marineengineer56
 Share

Recommended Posts

marineengineer56 Rookie

marineengineer56

Posted
Posted

Have a 2013 KRF750S Teryx  that starts and runs 10-12 seconds and then shuts down.  Also ,  notice the Multifunction Meter panel acts like it looses power. Turn the key off then back on, the Multifunction Meter panel starts up, then immediately shuts down.  The machine needs to set for at least an hour before trying to start then shuts down again.  [i.e. the symptoms repeat]  I believe the ECU is failing but don't want to make a $500.00 mistake  The service manual only addresses failing sensors, not the ECU.   Any ideas on how to test if the ECU is failing?  If it was a car/truck, my computer scanner will tell me.

Link to comment
Share on other sites
Travis Grand Master

Travis

Posted
Posted

It would lead me to believe a faulty Ignition Coil, but when you mention the Multifunction panel, sure sounds like the  ECU to me. I don't how to test them, i would contact your local Kawasaki dealer or Kawasaki directly to see if there is a procedure for testing one.

Link to comment
Share on other sites
marineengineer56 Rookie

marineengineer56

Posted
  • Author
Posted
6 hours ago, Travis said:

Did you ever get this sorted out?

Awaiting for  new ECU to show up Tuesday the 16th.  Contacted the local dealer, they said sure bring us the bike, pay $100.00 to Troubleshoot.  if it's the ECU. pay $550.00 for a new part plus 1.5 Labor hours @ $95.00/hour.  Said, nope, I will just replace it myself.

  • Like 1
Link to comment
Share on other sites
  • 4 months later...
marineengineer56 Rookie

marineengineer56

Posted
  • Author
Posted

Yes, it was a combination of a bad ECU and Fuse Box Corrosion.  Once the owner gets it started, runs fine.  Now the issue is the battery is not charging.  Replace the Rectifier, got 14 vdc on the battery.  Now am only seeing 13 vdc.  When I have time , gonna have to verify the alternator output.  Then I am gonna have to make a new fuse box, can't buy one as you have to buy a complete wiring harness which is like $400.00  which the owner doesn't have. 

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • TomW
      2012 Bog Horn - no power
      By TomW
      I had a problem 6-8 mo ago when the unit would not start . But you could see power on the dash. The starter solenoid was replaced and it has been fine until yesterday. When I started it up I noticed a high pitched noise coming from under the front. Like a alarmbuzz ..It seemed to drive fine so I went ahead and used it off and on for a hour or so . The noise would not go away . I parked it in the shed and lifted the hood . It seemed to be coming from the battery compartment ( where the new starter solenoid is) I jiggled the connections and the noise changed timbre and then the machine went dead. No power at all . No lights . When you cross the two poles on the starter solenoid ( previously last year it would start and run ) nothing. Checked the battery and it is fully charged . I checked the fuses inside the battery box and they all looked good  but I must be missing something. Anyone have a clue what I need to do next to R&R. The closest repair place is 2 hours away in Mississippi . Any help would be appreciated.
    • NDV45
      Kohler EFI Fuel Pump Power
      By NDV45
      I have  2008 Cub Cadet Volunteer Tracker.  Was running fine, parked and next morning electric fuel pump inop.  Checked voltage had 4.2 volts.  Swapped relays in fuse box, checked all fuses (good) and still low voltage.   Does the ECU control the voltage to the fuel pump or which relay controls the voltage to the pump?
      Have checked all wiring and not found any place it could be shorted (not saying I may have missed something). I am at a loss.  Need Help Please.
    • htrotte
      2011 HS500UTV-EFI Power Steering
      By htrotte
      Is it possible to add power steering?  If so where do I find parts?
    • great8redsfan
      2017 Challenger 500 No power on take off or hills
      By great8redsfan
      Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power.  They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil.  Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm. 
    • DLJ
      Hisun 800 shuts down
      By DLJ
      Have a Hisun 800 it runs for about 35 minutes then stalls. Crank's over but has no spark. Let it sit for 15 to 20 minutes and it starts and runs again for about 35 minutes. Changed the CDI / ECU controller and still does it.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...