Quantcast
Jump to content


Recommended Posts

Posted

Hello All,

 

New to the site. I searched a little an dI am sure it has been addressed but I do not see. My current windshield is too large and does not fold up enough to open trunk. I will often have to trailer it at speeds of 75 MPH. Any suggestions on a folding windsheild tha tyou were please with that would allow for room to open trunk as well as get to the radiator.

 

Thanks

Spencer

Posted

Got this from SxS stuff doesn't seal real good but stops the wind. I reinforced just above the hinge point with old bed frame angle iron, had more flex then I liked at 30 mph. It will allow to open the trunk 

20210327_075957.jpg

20210327_080018.jpg

Posted

If you get this style you'll have to adjust it up till the trunk opens, then it don't seal tight to the hood. Putting foam tape on rollbars first helps to seal in winter. I'm in MI., it gets cold here. 

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Topics

    • By Sammy
      Runs fine just putting around the yard. Get it out on the road and about a half miles it runs out of gas. Let it idle for a few minutes and it will run for another half mile and do it again. Replaced both fuel pumps and filter. Does anyone know if I can get rid of the factory fuel pump?
    • By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!
    • By Blekntowkz
      I have an X3 Max and I currently run the Can-Am rearview mirror alongside a Swamp Donkey stereo system mounted to the roof. Is anyone here familiar with this exact setup? 
      I’m looking to upgrade to a proper can-am Maverick x3 max front windshield made of glass so I can run a manual wiper. Does everything clear the stereo and mirror mounts just fine, or are there clearance issues? Also, which glass windshields out there are actually worth spending the money on?
      I currently have the Can-Am hard-coated poly windshield, but I am really tired of not having a wiper and having to constantly stop and squeegee after hitting a few mud puddles or dealing with this Michigan snow, mud, and water holes!
      Any advice would be huge.
    • By lincolnsq175
      Ive searched and cannot find any performance parts that fit my machine.
      I have a 2020 coleman ut400.
      Im looking for machined sheave kit, programmers, cdi, exhaust and intake.
      I know these are yamaha rhino clones but are they rhino 450 clones?
       
      Any info is appreciated.
    • By Fmaxiron
      I just purchased a 2023 Honda Pioneer a couple of weeks ago and had the hard roof and a front Honda Pioneer windshield installed at the shop before taking ownership. As things are drying up here in NC, the grass and dust are beginning to fly right through the back of the cab while driving. I was wondering if anyone has any good recommendations on rear windshields, dust panels, or mesh screens to help stop this?
      Thanks a lot!
×
×
  • Create New...