Quantcast
Jump to content

Unbelievable!

rocmoc

By rocmoc
in Joyner UTV SxS Forum

 Share

Recommended Posts

rocmoc Grand Master

rocmoc

Posted
Posted

Finally got the new skid plate on and everything buttoned up. Took the Trooper out for a little run. I WAS FLYING! Where I use to have to gear down in the sand, just gave it more gas and she took off. That was in 2WD with NO locker engaged. A hill I use to power up a little, I decided to just crawl up. Not even a spin. I was flying across the desert running between 50 - 60 mph crashing thu the washes. I was pushing it on purpose for the first time since the new driveline and rims/tires to see what it would do or what would break. I tore the rear fenders off from maxing the travel. I thought I had cut enough of the fenders away but now there is very little fender left. I am getting it dialed in. Rear tires are good at 24 lbs and springs are great. Front tires are down to 15 lbs but I will take more out. Front springs need to be soften a little more. Could not even feel the washboard. The thing is FASTER with the high final gear ratios with the BIG tires. The powerband has lengthen and is more usable. It just keeps pulling thu the gears. First is still a creeper and I will push it more before Moab. Just Unbelievable, I am soooooo pleased! At speed, no need for power steering but creeping, would be nice.

rocmoc n AZ/Mexico

Link to comment
Share on other sites
Guest Lenny

Guest Lenny

Posted
Posted

That sounds real encouraging. When you say you can just crawl up a slope, what would you say the angle of the slope was? How is the sand your running on, is it coarse or sort of powdery fine? I'm still planning on getting 13.50 x 15 paddles. After what your saying, it will be a pretty fast sand bulldozer with big paddles. Maybe I'll start a towing business. I'll tow othger UTV up hills they can't make but wish they could. Now they will be able to say they made it. :P Where I ride in the sand most of the time is Coral Pink Sand Dunes in southwestern Utah. The sand is powdery and with the stock tires I had to be careful, I could get stuck but generally was able to make it around sorta of ok. When I ran 25" paddles, it made a huge difference and could nearly go anywhere but too small, would still dig in too much. I havn't ridden at Dumont yet but was told that the sand is coarser and staying on top is easier and climbing better.

Lenny

Link to comment
Share on other sites
rocmoc Grand Master

rocmoc

Posted
  • Author
Posted

Coarse but I was comparing to past performance on the same sand. Closes power/blow sand is 4 hours away. Slope is about 45 degrees but it is the large ruts with boulders that makes the challenge. We have tougher hills of which I climbed a couple of weeks ago with the bigger tires, no problem. I didn't trying crawling but powered. Next time I will try to crawl, some time in the next week.

rocmoc n AZ/Mexico

Link to comment
Share on other sites
Quacks Rookie

Quacks

Posted
Posted
The thing is FASTER with the high final gear ratios with the BIG tires. The powerband has lengthen and is more usable. It just keeps pulling thu the gears.

Rocmoc did you actually change the gearing in the diff or do you mean the change that bigger tyres gave to you?

Link to comment
Share on other sites
brostar Proficient

brostar

Posted
Posted

Good on yar roc, I'm pleased it worked out and I'm sure a few Trooper owners will be following suit. Sounds awesome. Hey didn't Lenny say he was going to fabricate new fibreglass front guards? If that's the case Lenny sounds like a rear guard will be needed now. The same shape as the originals but flared up out of harms way. You never know, could be a nice little earner for you. Just a thought.

Cheers Mike.

Link to comment
Share on other sites
Guest Lenny

Guest Lenny

Posted
Posted
Good on yar roc, I'm pleased it worked out and I'm sure a few Trooper owners will be following suit. Sounds awesome. Hey didn't Lenny say he was going to fabricate new fibreglass front guards? If that's the case Lenny sounds like a rear guard will be needed now. The same shape as the originals but flared up out of harms way. You never know, could be a nice little earner for you. Just a thought.

Cheers Mike.

I will be doing it hopefully this spring, I'll have my long travel suspension done 14.5" and will need them. I'll be making molds so more parts can be pulled. I have expierence in fibreglass so it will be quite simple for me. It's just a lot of body sculpuring type body work to developoe the form. Actually I'm looking forward to the project. For now, just do temporary fender clearance fixes. These fenders will not only address the clearance problem but the mud slinging problem as well. Both fronts and rears. I'll be allowing for 31" tires and 14.5" of travel.

Lenny

Link to comment
Share on other sites
rocmoc Grand Master

rocmoc

Posted
  • Author
Posted

Just remember with the 31" tires you have to adjust the front A-arms and hammer the firewall tube a small amount to assure clearance. I will take photos. I know I owe the group a bunch of pics. Have be more concern with finishing the Trooper so I could play again.

rocmoc n AZ/Mexico

Link to comment
Share on other sites
Guest Lenny

Guest Lenny

Posted
Posted

When you adjusted the A-arms, I assume you adjusted them to move the wheel forward for firewall clearence. When I do the fenders, I will look at what frame modifications will or will not be necessary. I'm not going to stop short just to avoid having to modify a frame member. Figure if I'm going to do it, I'm going to have it be right for once and for all.

Lenny

Link to comment
Share on other sites
rocmoc Grand Master

rocmoc

Posted
  • Author
Posted

Yes but there is not a lot of adjustment, that is why you have to make the final adjustment to the lower firewall tubing. My post of my tire installed talked about how much adjustment I was able to get out of my Trooper. While there are a lot of threads in the helm, Joyner did not allow for moving the A-arm for ANY adjustment.

rocmoc n AZ/Mexico

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • buckrub
      trying to finish assembly "new" 2021 Coleman ut 400
      By buckrub
      Hey guys! Newbie here. I'm an old man who's better with plowing a mule (4-legged kind) than these newfangled beasts. I, and a friend of mine, just bought new Coleman sxs and are having to finish the assembly. I've been reading on this site and I'm falling on the mercy of you experts. The only way I'm an expert is that an "ex" is a has been, and a spurt is a drip under pressure. LOL First off, the 2 buggies have no ignition switches. They seem to mount on the dash, not the opening in the steering wheel shaft cover, so we ordered new ones that are supposed to fit. They are 8 inches long, and have a 4-wired white plugin which is slightly rectangled when looking at the end of the plug. The trouble is there's nothing to plug into. There is a three-wire grey plug close enough to reach the four-wire plug, but of course, they are not compatible. 
      Secondly, the blinker, light, ect. unit on steering wheel just spins around when touched. I see no way in heaven or earth to secure it. I've looked at a diagram on the Powersports site, but can't detect how it mounted. Fellows I'd be so grateful for any help with this. Me and my mule will even plow your garden for free, for your help. LOL 
       
    • nods
      2022 sector 750 GAS powered: Codes E-113, E-108, E-123, E-132, E-650. What are these?
      By nods
      Less than 40 miles can barely start. Dealer is working with Hisun on a number of other issues on this UTV. Can not get clear info on the meaning of these E codes this is getting. Anybody have some clear info for me?
    • joeam
      2018 Landmaster Tw450E will not run down the road?
      By joeam
      I have a 2018 TW450E that runs in my yard and slow good just will not go down the road seems to be running out of fuel where should i start? I have replaced both fuel and air filter drained gas and tried a small auxiliary tank same issue i have ordered a new vacuum fuel pump to try next anyone in Texas that works on these?
    • Nathon S.
      Bennche 700 EFI Bighorn New Fuel pump not working
      By Nathon S.
      I have a Bennche 700 EFI Bighorn. I’ve recently been unable to get it to start. After a little troubleshooting I realized my fuel pump was not pumping fuel. This weekend I emptied the gas and replaced it with new. I replaced the fuel pump, fuel filter and fuel injector. I also replaced the battery, spark plug and made sure all my fuses and relays were good. I have confirmed that the float on the fuel pump is not obstructed. The UTV is about 12 years old and has less than 100 hours on it. It has not run in over a year.  Not sure whats going on?!? After doing a little reading I'm leaning towards it being an issue with the ECU or perhaps a faulty wire in the wiring harness. Anyone have any ideas on where to start looking or what I could be dealing with? Any help is appreciated, thanks in advance!
    • Hugh
      2018 Hisun Sector Crew 1000 engine die after about 15 minutes run
      By Hugh
      My 2018 Hisun sector crew engine cut off after about 15 minutes run. There is no indicator of what is wrong, no error code just die and won't restart until it cool down. I notice that the fan is not running but the temp indicator is on low temp, no overheat indicator. I checked the radiator fluid, it is cool to touch.
      Cooling fans are working, I can hear it running once awhile if I can get the engine warm up enough.  Thank you for all the help.
       
      Hugh

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...