Quantcast
Jump to content


Hisun utv wont start no elec on dash

Rick A

By Rick A
in Hisun UTV SxS Forum

 Share

Recommended Posts

  • 3 months later...
aefron88 Community Regular

aefron88

Posted
Posted

Candl,

For little more information:

What year and model?

When did this start? Did you have any prior recent issues?

Do you own a volt meter or 12v circuit probe so I can walk you thru troubleshooting?

  • 4 weeks later...
candl Newbie

candl

Posted
Posted

2017 sector 550. This rig is new to me, second time using it went about 7 miles and when I turned it off it made a air escaping or winding noise and the electrical blinked then nothing. nothing. I do have a circuit probe and would love to be walked through troubleshooting thank you.

candl Newbie

candl

Posted
Posted

I ordered a main relay fuse but it came with four wires instead of three. Haven't seen any of these with three wires like the original, but figure its like a replacement windsield wiper motor where you just have to figure it out and get a plug to match? Am I correct in that assessment?

aefron88 Community Regular

aefron88

Posted
Posted

Ok so just to recap since yours isn't the original post:

You shut it off and it made an "air escaping or winding noise" and now it wont display anything or start correct? Lights don't work with the key on?

I'm trying to figure out what the noise might have been but blanking on anything.

Have you checked the battery voltage? Should be at least 11.8V.

From there I would open the fusebox (little black box with 4 screws holding the cover) check that all the fuses are getting the same as the batt voltage (check between the fuse terminal and the neg batt terminal). Then check that all fuses are intact and not blown.

 

candl Newbie

candl

Posted
Posted

You are correct, no lights or electricity at all. All fuses are good, battery 12.3, no wires bad, no obvious anything. Went through all the wiring, looked at everything, No codes as I can't get it turned on to look.

  • 2 years later...
  • 4 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Topics

    • AaronD1982
      Massimo Buck 400S UTV Stator......?
      By AaronD1982
      Next problem with charging system to tackle, any help would be appreciated.
      New starter solenoid....check
      New Voltage Regulator...check.
      Dynamic test to Stator.....bang...pulling like 2 Volts AC
      Problem: Without pulling the part out and stranding the vehicle at the shop forever.... I am trying to find the correct stator or at least one that might not be exact for the Massimo Buck 400S, but fit and connect and do the job if that makes sense.... if anyone has any ideas, please shoot them my way.
    • BWF
      Landmaster LM200 Will Not Start
      By BWF
      I have a 2011 or so Landmaster LM200.  I cannot get it to start.  I turn the key and nothing happens.  The brake switch seems to be working, the ignition switch works.  The Coil is new the Voltage Regulator is new and the starter relay is new.
       
      I can connect the terminals on the starter relay and it starts right up and runs fine.  I just can't get it to start by turning the key.
       
      I am having a bit of trouble bleeding the brakes, not much fluid comes out at the calipers when I am pumping the brakes, though that an air bubble near the brake switch might make it not sense that the brake pedal is depressed.
       
      I am at a loss, please help!
       
      Brad
    • AaronD1982
      Massimo 400S Buck UTV Starter solenoid replacement
      By AaronD1982
      I recently purchased a 2019 or 2020 (no manual) Massimo 400S Buck Series UTV.  It ran fine for a couple days but the low battery light was flashing while it drove.  It then died in the field one day and I was able to jump the battery and get it rolling enough to get back to the barn.  It started both times I turned the key for a couple days after and when driven died 10 minutes later in the driveway.  Even after jumping it had no juice, but with the key out of the ignition it kept trying to start, a quick look on the Google machine and it suggested starter solenoid or ignition switch was the culprit.  Fair enough, let's just order a replacement solenoid, right?  No way Jose....the pin connector on the UTV is a 2-pin white plastic connector and the part received is a 4 pin.  How do I swap that and make it work?  Can I even?  Where do I find correct parts in the future?
    • Eman85
      Best place to find info on Hisun or Massimo UTV's
      By Eman85
      I have been searching and can't find much info on these units. Pretty surprising as every other thing I own I find a lot of info on. Researching for tech info and such it's like no one owns any of these yet I see them everywhere. 
    • MilSurpYinzer
      Altering running lights
      By MilSurpYinzer
      Anyone decent with electrical work that knows a good tutorial on how to make my running lights switch off all together but also turn back on when I need too? I'd assume that my lights are hard wired to the battery or the fuse panel.
      Vehicle is a Kawasaki Krx 1000
      I'm looking to ad IR driving lights for night vision and short of just putting black tape over the lights I feel this would be a more efficient option and it would be cooler. 

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...