Quantcast
Jump to content


Recommended Posts

Posted

So I'm out a deer camp and ran the sxs for 2 days.  The next morning, fired it up and headed out.  Made it about 50 yds then bogged down and died.   Restarted twice and only moved a few feet then would not restart.  Took the truck out for the day to hunt and when I got back I could hear the fuel pump kick on when the key was turned but it would still not start.  Added stabilizer to the fuel and put the trickle charger on it and tried again the next day, still the same - pump coming on and turning over but no start.  Other than spark plug, air filter or injector clog any ideas?  Out in the middle of nowhere so limited on resources.

Posted

Hi TapBoss,  This maybe beyond field repair, the electric fuel has a restriction/clog.  I had a similar problem with my Kawaski 750 Teryx (2008).  I would drive a little distance and bogged down, but not die.  I was able to drive at less than 5 mph back to camp.  Took it in for service, and then found out the problem.  The Teryx has the fuel pump in the gas tank.  I was very careful in filling the tank then, using a filter in the funnel.  Panty hose works as a great strainer, seriously.  Hope this helps.  Don N.

Posted

It sounds like your stator is going out, when the machine cools down it will run for a short time, and then shut off? When it shuts off check to see if you have spark, if not it is the stator or the ECU.

Posted

No, never started again after that incident. Got it home now, air box/filter clean but couldn’t find my spark plug tool to pull it. Have a new one arriving Wednesday so we’ll see then if plug is fouled. About at the recommended hrs for changing and I had been doing a lot of short trips. Will check fuel filter as well. 

Posted

Had similar situation. Road a nice long ride. Stopped to get a drink at a store. Machine started but wouldn't idle and died. Had to give it gas to keep running.

Got home sat a little and all was good. Changed the fuel filter and even though it's a new machine. Looked like paint chips inside the filter on the output nipple. 

I put a plastic filter on and haven't had any trouble with idle since. I'm going to get another injector and replace just to be safe. Once I get other issues taken care of.

  • 2 weeks later...
Posted

Update, replaced the spark plug which did nothing.  Pulled the fuel injector and it is working properly (mist) - but the video on youtube from Massimo states if you see 2 streams it's bad.  The fuel injector has 4 holes??  Anyway, added fresh fuel just incase, still no changes.  Battery is fully charged and engine will turn over like crazy but not fire up. 

 

Posted

Does it have spark? If not then is most probably your stator.  If it has spark then it is either your fuel injector is clogged, clean it with carb cleaner until you have a good stream of fuel; take off your air filter and spray starting fluid into the intake manifold try stating it; if it starts then it either your fuel pump or your fuel line.  If it doesn't start then it is electrical (stator, ECU or a wire)

  • 4 months later...
Posted

So after changing the spark plug, checking out the injector and air filter and putting in a new battery, my TBoss will crank over and start. However, the idle immediately starts to drop and it dies. When I first turn the key, you can hear the fuel pump prime as well. 
 

Not sure where to go from here. 

Posted

Just for giggles have you changed the fuel filter. There is a screen in the injector also. Don't know if it is serviceable. So may have to change the entire injector.

Had similar issues out of my Axis 500. Would not idle. Had to keep foot on gas at all times. Changed the fuel filter and that corrected the problem.

 

Actually it looked like oem painted the inside nipples of fuel filter and it started flaking off

Posted

Not even sure what it was, looked like lemonade coming out. The bottom of the jug appears to be an oily substance like cooking oil. What’s odd is the machine would start up then die every time with this in the tank. Back to running like new once we drained the tank and line completely and put in fresh fuel. 

Posted

He was given 5 acres by the owner of the property probably 20 years ago. The owner has since passed and his son and I take care of the place. This guy has gotten progressively worse since his passing. What sucks is he’s always there and we’re an hour away. We had a disagreement over him bringing someone else in to hunt the night I believe this happened. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Topics

    • By 180gtr
      Parting out a rolled Sand viper 1100. I will list some of the parts I have, otherwise ask me if there is something specific you are looking for. I am selling everything I have for $800. I am located near Glenwood Springs CO.
      SOLD ITEMS, I do not have these items.
      Wheels
      Tires
      Engine
      Transmission
      Axles
      Shocks
      Control Arms
      Things I have....These all came off of the running engine. I have video of it running if anyone needs to verify that.
      Throttle Body $90
      Starter $150
      Alternator $150
      Fuel rail, injectors, fpr $100
      fuel pump $70
      Map Sensor $50
      Full set of Guages $150
      Exhaust w cat, O2 SOLD
      Ignition Coil - SOLD
      Wiring harness and ecu SOLD
      Radiator, shroud, elec fan, overflow tank $200
      Fuel tank w sender $150 Has dent at base of fuel neck, no leaks
      I have a box full of misc bolts, nuts, etc.
      I will sell the Chassis or Frame alone for $200. The chassis is in pretty good shape, needs some cage repair and 2 areas straightened where control arms mount. If anyone had an automotive frame machine it would take a few hours.
      That would include....
      Brake calipers, lines, pedal, master cyl, E brake assy,
      Steering shaft, wheel
      Ignition switch, key
      Light bar frame, 2 lights
      misc hardware, spindles
      2 hubs, rotors
      Engine mounts
      Throttle pedal, cables
      Shifter, cables
      Clutch master, pedal
      I am sure I am forgetting something.
      I am parting this out of ebay right now, I just picked up another project and could use the room. No I will not take less than $700 for all of it or $200 for the frame. I do not need to sell it, I will make far more parting it out but would like the extra space in the garage.
      If interested I also have an 07 1000rr engine setup I would sell with the buggy for $650.
      Thanks!
















    • By J Cardwell
      2024 villian overheating shuts down to crawl mode. If I turn it off for 30 minutes power returns to normal. 
    • By oakhill
      When I am moving forward on my Hisun 500, the motor accellerates up and down while I have my foot on the gas pedal.  It also is not idling very well.  Both symptons appeared at about the same time.  What should I look for?  Thanks.
    • By gridlock
      After three years, my Sector completely died.  Something caused the hot wire under the seat from the charger to disintegrate, so the batteries weren't being charged.  The batteries weren't charging 100% anymore, so decided to convert to lithium.
      As most others have done, I went with 4-48v batteries in parallel, as I believe that will be plenty of amp-hours for my needs, but can always add more if needed.  I went with LiTime wired CAN batteries and mounted their digital gauge on the dash above the current one, which fit perfectly.  I didn't think the existing battery brackets worked well for the new batteries, so made my own out of aluminum L rails, which makes it much more secure (and saves a few more ounces :)).  Since I wired them in a 'balanced' configuration, I had to make all new cables from 0/1 gauge wire and 8mm posts.  I updated the DeltaQ charger to profile 233. Cleaned everything up (I must have vacuumed 20 pounds of dirt!), put it all together and... wham!
      So far, it definitely is better than with the original AGM batteries.  Sustains speed better going up hills, and seems to have plenty of reserve current.  The difference in weight with 4 LiPo vs 8 AGM batteries surely doesn't hurt!
      Thanks to everyone on this forum, but special shoutout to GNFO who was a big help.
      A few questions:
      In the 'any tips' thread, EVSupport mentioned reprogramming the Sevcon to reflect the new discharge curve of the lithium cells, but I didn't see any more info about that or how to do that.  Is there any more info about that?
      Have folks replaced the onboard 12v battery, and if so, with lithium?  I'm not sure why there is a 12v battery; why didn't they just step down the current of the 48v system to provide power to accessories?
      Is there a recommendation as far as charging with the lithium conversion?  As far as I understand, it is better to let lithium batteries discharge somewhat (but not completely) than keep them charging all the time.  What do you think?
       


    • By Ironeagle
      My 2018 Massimo MSU 500 was operating just fine.  I parked it for 2 weeks in my shop now the unit starts and runs great but at 18 MPH it cuts out. It's not the seatbelt safety switch that engages at 10 MPH if it is unbuckled. I purchased a new ECU but that did not resolve the problem. No error code is presented. I reset the ECU replaced the fuel injector, coil, sparkplug and spark plug wire. Same response. I don't mind replacing faulty components but don't want to chase parts and hope for the best. Any ideas??
×
×
  • Create New...