-
Similar Topics
-
By Edelbrock
So I'm interested in a side by side of some sort.
Not sure what make/model to even look at.
I would plan on riding on trails with very rough rocky terrain and plenty of mud. Maybe sand once in a long while. I like LOTS of power and drive fast, but also like a trail that is a challenge to get through. I think 4x4 would be a must. I like the idea of a supercharged engine, but I have never owned one, and would be a little concerned about long term reliability or expensive difficult engine repairs. If anyone knows quads, my favorite was the 2008 Polaris Outlaw 525 IRS. For dirt bikes, I raced a 2008 KTM 450 SX-F. So that gives you an idea of what type of off road stuff I liked.
I don't like "utility quads" or "trail bikes". And likewise, I dont want a turd UTV. I want something that looks awesome and performs awesome. 2 seater with some cargo capacity at the minimum.
Thoughts?
-
By FTG-05
I want to ditch my Kubota RTV-XG850 and its moronic twitchy throttle design flaw, get rid of the problematic engine and the 40 mph purposely throttled speed.
So far, I'm looking at the Honda Pioneer 1000 and the Polaris Ranger 1000, both of which have 1000-1500 lb payload bed capacity.
What other makes and models should I be looking at?
Thanks for the help!
-
By lincolnsq175
Ive searched and cannot find any performance parts that fit my machine.
I have a 2020 coleman ut400.
Im looking for machined sheave kit, programmers, cdi, exhaust and intake.
I know these are yamaha rhino clones but are they rhino 450 clones?
Any info is appreciated.
-
By CRV
I’m need a couple parts. Diff. Lock Actuator mainly. But I would like to find a donor that maybe has bad motor or something along those lines.
if anyone has or knows of anything please holler at me
thanks Randy
-
By Kingfish
The conversion took about 350lbs. off the vehicle. It never rode great, but now I feel every crack in the road. I have backed off spring compression nut to the point just under where they would move around if suspension was at full extension, but it is still very stiff. I would like to put some softer coilover springs on it, but I have no idea what the spring rate is with the original springs so I would just be guessing on what to order. Does anyone have the data for the original spring compression rate? I am willing to give up a little ground clearance for a softer ride. Right now when sitting still the rear suspension is at or near full extension and the rear tires have several degrees of camber which will cause uneven wear if allowed to continue in this state.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.