BANG IT'S DEAD -MAYBE
-
Similar Topics
-
By great8redsfan
Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power. They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil. Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm.
-
By tim hughes
does any one else have a slipping belt on the hisun ...i put new wet clutch one way bearing new belt, cleaned primary and secondary and still get slight slippage
-
By Richard shepard
I have a 2021 colman 400utv engine will start and idle, as soon as you hit throttle to move engine dies and will only start when you throttle it, let off throttle it dies, I replaced the injector and plug still the same, anyone have any other ideas
-
By Timpiker
My UTV is a few years old and gets very little use. I just noticed the drive belt slapping the plastic guard and making some noise. The manual tells me how to replace it but not how to tighten it. Apparently, there is no adjustment. Does anyone know if there is an adjustment? Is the belt supposed to have a lot of slop in it?
-
By NewtoUTV
I have alot of issues with this machine that I'm trying to figure out and fix. Today when I was fixing the shifter I see this cable connection that is not connected to anything. I looked and can't find where it might need to be. Any ideas would be greatfull.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.