-
Similar Topics
-
By J R
Hi, I just bought a used 2015 MSU500 with 365 hrs on it. After riding it the UTV seemed sluggish and would not climb a moderate hill without getting a running start in low range. Took it to a repair shop and they told me that the clutches were burnt and slipping. Had the primary clutch replaced and afterwards was told that the compression of the cylinder was only 80psi, which I was told was 100psi below original compression. I've bought all parts necessary, including new crankshaft and bearings to rebuild the motor. My question is, does anyone know if a 700cc top end kit will bolt onto the 500 motor case?
-
By Dreadnought
I've searched the forum but don't think I found a solution.
I just bought a used 2022 UT 400 with only 31 miles on it. Often I have to rev the motor just a little to get it to shift into forward or reverse. The original owner told me about this and said it needed the cable adjustment that you so often read about. It also jumped out of gear a few times and did grind a little but not very often and only under heavy load like going up a steep dirt road. After reading lots of posts I figured it must be the short shifter throw so I did the shifter extension modification. It didn't help at all. I thought, should I increase the idle speed? The tach reads about 1600 rpm at idle but it doesn't sound that fast to me. It doesn't seem like cable adjustment because it clicks right in gear with just a few more revs. Any ideas?
Thanks for any wisdom.
-
By Dirt Road Adventures
Hello my name is Andy Seddelmeyer and I am from Decatur Indiana. I own a Honda Talon X4. I am also the owner of Dirt Road Design.
I make accessories for SXS's but not limited to Honda. dirtroaddesignllc.com is the website if you would like to check it out.
-
By Dirt Road Adventures
What are your thoughts on our most popular products?
Everyone has loved them so far, just wanted to get your opinion on them. Always room for improvement though.
You can find more information, pictures as well as order at http://www.dirtroaddesignllc.com
All parts are made from PETG a renewable plastic that is UV, chemical and heat resistant. Parts are designed to take advantage of 3d printings advantages and extensively tested to ensure strength and durability.
We take Great Pride in providing the best customer service, as well as helping you to enjoy your off road passion.
Any questions feel free to ask
-
By projectsnwork
New to the UTV scene. We picked up an RMAX about 18 months ago. So far so good. Looking to spend a lot more time on it this year.
-
-
-
Gallery Images
![render[2].jpg](https://www.utvboard.com/uploads/1266430190/sml_gallery_475_29_20648.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.