Quantcast
Jump to content

Recommended Posts

well we have finally started tear down on our new shop project vehicle sent to us from Utah. we will be posting pictures and tutorials as we go. for now motors is getting machined to be able to take a set of our 9.0-1 compression pistons with the teflon coating on the skirts

post-339-0-12603200-1336085416_thumb.jpg

  • Like 1
Link to comment
Share on other sites

  • 3 weeks later...

its coming along had a little wait in machining just because there were so many people trying to get stuff done for the long weekend.

we are waiting on the rods,pistons, and crank to come back from cryogenic freezing.

cryogenic freezing is the process in which the parts are submerged into a -300* environment for undisclosed periods of time making the molecules "relax" and ultimately resulting in a virtually stress free rod and crank.

this assembly will dissipate heat 30% more efficiently, and it will take much more abuse.

cams should be back this week.

we should have some pictures up of the final assembly by the end of the week.

Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By ATRican
      Just got a 2024 Odes Junglecross 800 cc four door 5 seater today. Feel free to share advice on longevity tips and common failures of this model.
      AR
    • By great8redsfan
      Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power.  They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil.  Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm. 
    • By Buddee
      Put a new carb on the 500 to replace the leaking OE one.  Machine idles fine and mid and top end runs great.  It tends to have a hesitation right from the start - bottom end.   Thinking it may be the air/fuel screw??  I didn't do anything with the carb out of the box and is it direct replacement for my machine.  Of interest is the manual choke doesn't seem to work very good now.... wonder is it getting too much air?
       
      Any help appreciated!
       
       
    • By donny
      Hey everyone new to forum I have a 2014 Odes raider and a 2009 Suzuki Ozark 250 both down atm 😔
    • By DLJ
      Have a Hisun 800 it runs for about 35 minutes then stalls. Crank's over but has no spark. Let it sit for 15 to 20 minutes and it starts and runs again for about 35 minutes. Changed the CDI / ECU controller and still does it.
×
×
  • Create New...