We just bought a used 2017 American Landmaster TW450. No hour meter that I can find, so not sure exactly how much it has been used.
The first 2 days we had it, the starter was a little sketchy, but it started after 2-3 tries. Sometimes when turning the key, we would hear a loud metal "clink" sound. Like the starter made contact, but didn't have enough power to turn.
THIS MORNING... Turning the key, we hear a single click sound. That's it. Even with a new battery, the starter is still doing the same thing. Both batteries (old and new) were reading 12.8 volts on volt meter. So I'm wondering what else could be going on? Any ideas on what to look for would be greatly appreciated...
So i have a 2011 EFI 700. the SxS will crank right up everytime without any issues. If i let it run or ride it for about 10 mins it will shut off and then it may turn on if i am lucky but most time i have to let it sit for like 3 hours and then it will run again. i have done the following
-New fuel filter
-New spark plug
-New coil pack and plug wire
-New air filter
Also could i get a grizzly 660 engine and put in it or would it not work.
Hello, I have a 2013 500 utv hisun. Was running ok and cut out while parked. Bike will not start now. It turns over, but won't fire. I have no spark and no fuel. I replaced fuel pump, ignition coil, spark plug, cdi, voltage rectifier and all the fuses and relays. Could bad stater cause no fuel because I can't hear the fuel pump priming. Any info on where to start looking for problem.
Very new to any forum. Haha We have an 09 R2 joyner renegade 800cc. We are unable to start it. It has been sitting for a few seasons. It has spark(new plugs), it get gas, fuel pump works(new), fan comes on on initial key turn, sounds like system doing its check. It's turning over but nothing. Clean fuel, gas tank cleaned, fuel going through all the lines. Relays and fuses checked and pulled and reseated. New battery even. Thanks yall.