Quantcast
Jump to content


Recommended Posts

Posted

Just bought a used Stampede.  Want to get it looked over and serviced.  U cant find ANYONE to work on these things. Tried Polaris, etc dealers... help.  

 

Louisville. Ky

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Kevin Ullman
      View File 2015 Polaris RZR900 Service Manual
      2015 Polaris RZR900 Service Manual
      Submitter Kevin Ullman Submitted 04/23/2025 Category Polaris  
    • By Kevin Ullman
      View File 2013-2016 Polaris RZR 570 Service Manual
      2013-2016 Polaris RZR 570 Service Manual
      Submitter Kevin Ullman Submitted 04/23/2025 Category Polaris  
    • By Wolfpaak
      I think this part is causing a high idle problem(4000 rpm at start up) in my 04 R4 Joyner. I took it out and cleaned it and the problem went away. I just went out to start my SXS and it's idle jumped up to 4 grand again. Can someone tell me what this part is called so I can search for a new one. Or can you point me towards a source. 
      Thanks in advance. 
      Kenny


    • By Mmcleary
      I have a 2018 Textron Stampede that has a leak on the passenger side rear end. Definitely looks like a gasket has gone bad, but I’m not sure what fluid I’m replacing?  
    • By Jon Spruill
      Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
×
×
  • Create New...