Quantcast
Jump to content


Recommended Posts

  • Alex changed the title to 2021 hisun 750 Coolant dripping
  • Alex changed the title to 2021 Hisun 750 Coolant dripping
Posted

From the weep hole on water pump only when I start it few smal drops come out after few minutes of being started and it looks like it stops completely 

Posted

That means the seal in the water pump is weeping a bit (that's why it's called a "weep" hole), but not failed--as it stops as the engine warms I would not worry about it too much--one could argue it to be "normal", but keep an eye on it...

Posted

IS it 3 days "new to you", or just 3 days old?  How many miles/hours on it? If just "3 days new" I would not worry about it, it takes a while for the seals to seat...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Topics

    • By John Gubancsik
      After sitting this winter in a garage, I noticed coolant under the side by side when I went to get it out.  Does anyone know what would cause the coolant to leak out while in storage?  Any assistance would be greatly appreciated.
      Thanks,
      John
    • By NewtoUTV
      I just reassembled the engine to fix the shifting issue.  I ran the unit for about 15 min and it started to overheat.  I thought it was an air lock and let the unit cool down and opened the radiator cap and head burping and then looked under the machine to find coolant.  I found where it is leaking from, see attached photo 1.  I added coolant and it doesn't leak until the fan starts.  When I put the engine back together I may have installed something incorrectly? Image#2 one shows a part that I was not sure where it goes, I ended assuming it was part number 23 in image #3.  Is this correct?  Could this part be the issue why I am getting leaking?
       
      attached photo 1

       
      image 2

      image 3

    • By Pilot1996
      So my 2022 Tracker 800SX developed a coolant leak. Under pressure there was a pin hole size leak which was spewing coolant towards the firewall. Upon removing the tank I discovered it was bulging pretty severely such that it caused a small crack. Has anyone else experienced this? I suspect either a faulty tank or perhaps a faulty tank cap (rated at 15PSI).
    • By Tony 1234
      I think I have tried everything.done a compression test,holding  at 100psi so I don't think the head gasket is blown.Used a raditatior vaccuum to refill radiation to make sure no air bubbles,bled system at motor.Removed water neck and can see center of impeller spinning,I just don't know,am I overlooking something simple? Any advice would be helpful,Thanks
    • By Tarak1980
      I have a Coleman HS400UTV-5 got it manly for hunting and spending time with the grandkids
      The one problem I am trying to avoid. My son borrowed it last summer and said it ran hot so he added water to it . I do not know how much he put in so I would like to drain most of it and add new coolant to protect it this winter. I can find no drain cock or any way of draining it besides loosening a hose.  Any suggestions ????
×
×
  • Create New...