Quantcast
Jump to content


Massimo Buck Check Engine Light

Michelle Holmes

By Michelle Holmes
in Massimo UTV SxS Forum

 Share

Recommended Posts

  • 2 months later...
kenfain Experienced

kenfain

Posted
Posted

TapBoss makes a good point, it really does seem to be related to the oil change. Check the things he's suggested, if that doesn't help, then you'll need to find out what trouble code is causing the check engine light. 

motojoe Contributor

motojoe

Posted
Posted

Check the connection from the oil sending unit to see if it has a good connection and also check the ground.  If it happened just after an oil change make sure that you have the correct amount of oil in the crankcase, also sometimes the low oil sending unit has to have some time to refill after a oil change.

  • Alex changed the title to Massimo Buck Check Engine Light
  • 5 weeks later...
kenfain Experienced

kenfain

Posted
Posted
2 hours ago, U.P.Dan said:

My buck 450 is running good, however I now have the check engine light....code is 0850. Where can I find out what it is? Thanks, Dan

Welcome to the forum U.P. Dan, sorry, but I can't easily answer your question. 

I suggest that you start a new thread, you'll get more exposure, and that should make it easier to get a faster response from someone who can answer your question. 

Good luck!

  • 3 weeks later...
  • 2 weeks later...
motojoe Contributor

motojoe

Posted
Posted

Bleed oil from the oil filter sometimes an air pocket or the filter does not have oil in it and will cause the light to come on.  To bleed the oil filter loosen the filter crank over the engine until oil comes out then re tight the oil filter, start engine.

  • 10 months later...
Joe Breaux Mentor

Joe Breaux

Posted
Posted
On 7/12/2022 at 10:34 PM, Michelle Holmes said:

Massimo sent me a new throttle assembly, injector and still has no power.  I’m getting very frustrated, wish I never bought.  Nobody in San Antonio Texas will touch it

Welcome to the very large  world of dis-satisfied Massimo owners.. I bought mine in 2017 . it broke on the first day.. To date, Massimo has never paid one dime for the many many repairs it needed.. only one shop will touch them in my state.. CASH ONLY up front!   Good luck........... BTW.. is that a Lhasa Apso in your pic?  looks just like mine that passed at 14 yrs old .. Loved that dog

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • AaronD1982
      Massimo Buck 400S UTV Stator......?
      By AaronD1982
      Next problem with charging system to tackle, any help would be appreciated.
      New starter solenoid....check
      New Voltage Regulator...check.
      Dynamic test to Stator.....bang...pulling like 2 Volts AC
      Problem: Without pulling the part out and stranding the vehicle at the shop forever.... I am trying to find the correct stator or at least one that might not be exact for the Massimo Buck 400S, but fit and connect and do the job if that makes sense.... if anyone has any ideas, please shoot them my way.
    • Thearm
      TW 450 dies on steep hill
      By Thearm
      I have a 2018 TW450 that runs fine on flat ground but dies out when under load going uphill. Changed the gas filter and spark plug with same results. Letting it set for a few minutes it will run until it hits a incline. Belt is not slipping, but the engine just dies out and doesn't even want to run in neutral. Any ideas as to what I can try is appreciated in advance. Also only run non-ethanol for fuel.
    • BWF
      Landmaster LM200 Will Not Start
      By BWF
      I have a 2011 or so Landmaster LM200.  I cannot get it to start.  I turn the key and nothing happens.  The brake switch seems to be working, the ignition switch works.  The Coil is new the Voltage Regulator is new and the starter relay is new.
       
      I can connect the terminals on the starter relay and it starts right up and runs fine.  I just can't get it to start by turning the key.
       
      I am having a bit of trouble bleeding the brakes, not much fluid comes out at the calipers when I am pumping the brakes, though that an air bubble near the brake switch might make it not sense that the brake pedal is depressed.
       
      I am at a loss, please help!
       
      Brad
    • brewski
      installing light bar on kubota rtv 1100 x
      By brewski
      I just purchased a 2025 kubota rtv 1100 x cab esd esnting to install light bars on the roof it appears to be prewired for lights how do lights mount and what kind of switches do i need
    • AaronD1982
      Massimo 400S Buck UTV Starter solenoid replacement
      By AaronD1982
      I recently purchased a 2019 or 2020 (no manual) Massimo 400S Buck Series UTV.  It ran fine for a couple days but the low battery light was flashing while it drove.  It then died in the field one day and I was able to jump the battery and get it rolling enough to get back to the barn.  It started both times I turned the key for a couple days after and when driven died 10 minutes later in the driveway.  Even after jumping it had no juice, but with the key out of the ignition it kept trying to start, a quick look on the Google machine and it suggested starter solenoid or ignition switch was the culprit.  Fair enough, let's just order a replacement solenoid, right?  No way Jose....the pin connector on the UTV is a 2-pin white plastic connector and the part received is a 4 pin.  How do I swap that and make it work?  Can I even?  Where do I find correct parts in the future?

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...