Detbohica

I'm looking for a Transmission. I have busted the housing, and u joint and not sure what else yet, it will get disassembled in the next couple weeks. Baja 1000 is first, but looking to find out what anyone has if I need it. Thanks Casey

Where is the computer located on the T4, my intention is to do a test this weekend, and most likely will need to swap the computer where we are testing at. Also recommended tools to replace the computer. Second question oxygen sensors I also want to test disconnecting them, What I though I heard is there are 2 of them on the exaust manifold. Pictures would be very helpful, since the manual doesn't show a good location.

Lenny got the computer. Just back from 3 days at the Baja 500. Will try to get the computer changed soon but weather is getting hot already to spend too much time testing.

Did you leave them unplugged?

Low gear I'll keep the post updated. If it was the ECM or not. Then I will decide if I want an extra or sell Lenny's.

Thanks Lenny, once I get it I will swap it out and hit the desert for a test ride and update this conversation.

Lenny I will take it. Dumb question same computer for the T-4. I understand once I buy it's mine if I don't need it. I'll probably hold on to it or put it on eBay.

Lenny I will take it. Dumb question same computer for the T-4. I understand once I buy it's mine if I don't need it. I'll probably hold on to it or put it on eBay.

I agree I like your page also. I will have some reading to do as I bookmarked it also.

CPS??

Throttled down to almost the point off turning off then chugs and regains rpm's again

I'll pass also, at this rate I'm going to end up with a Joyner VW or a bad ass Bronco early 90's

Thanks to all so far. I hope to get time this weekend to dig in with the mechanic I will relocate fuel gauge if possible, I believe it is dropping but unsure because it sounds starved of gas. New Bosch pump put in a few months ago, could be an intermittent bad pump. It is has happened both hot and cold, but moe when hot. I will keep this thread updated until the problem is fixed or I put in VW motor. I will also IAC valve and the computer for moisture. Will also see if someone has the equipment to read the fault codes.

All I have been reading but not finding what is happening to me yet. I have been fighting the same problem for months now. The t-4 will flat out go at times then it will loose power down to 500 rpms or so for 5-15 seconds then you hear it regain the rpms and off I go again. I have completely cleaned the gas tank, repositioned the filter changed the filter numerous times. Added the a higher pressure Bosch pump. I thought it was a dirty tank with debris getting in the way since when I took my foot off the gas it would recover in a few seconds 5-15. I read the post about the IAC but most of them were about over revs. I thought maybe it was the computer protecting itself, if too high of revs. I'm too the point just just throw this engine out and put a VW in it.

This weekend race is in the Laguna Salada just west of Mexicali the race is a 200 mile night race. For the Baja 500 I will also be there near the start and moving Erendira by 2pm to watch them again and provide pit support. I will update with a few photos and any great videos of the Trophy Trucks.

I added a roof and rack independent of each other plus a front air deflector. I'm ready to help chase the night race this weekend.

Riding near Mexicali I love getting to the Laguna Salada area near the canon de Gudalupe it is straight forward Baja racing terrain. There is so much open riding area it is insane, but if you don't know the area or don't has Gps that works I.e. Lowrance or equal you can have big time problems. I will get over to your shop one day since I'm probably on of the closest, but not the closest.

Great stories guys. Glad you had so much fun

Bummer your page requires a flash player. A no do with the IPad will check it out on my laptop tomorrow.

$1 dollar nice. Will this work for the T2/T4?

I do the same as Rocmoc.

Opps can't spell. Charlies no worries, I always get off on tangent myself...... Roc thanks for being tricky.....Dang Mods and the power of the pen!!! LOL

Wow what persistence.

I'm not making promises but I will try to come for a day trip if possible. Once I cross the border it is an hour and 30 minutes for the Jamboree. I want to see what everyone has done to there's since mine is close to stock still.

Can we get on track is this a clutch talk or doffs. LOL.