-
Popular Now
-
-
Similar Topics
-
By schreib69
I just bought an older (2008) Teryx 750 and am having some concerns. Hoping of course, that most are not too big. . . but more knowledgeable folks like yourselves will surely have some ideas. Thanks in advance.
-- about 2700 hrs, camo version
-- Starting: after not running much at the auction site, I tried it and it was tough to start but half of this was likely I did not quite know the tricks for how long to keep the choke on. However, once it started it was kind of hard to keep running until it warmed up(once warmed it starts perfectly every time with no choke). Now, back to running after the first ignition: I had to hold the RPM's up a bit to keep it running and when doing so it sounded as if a little gnome was inside the engine pounding on something at random intervals. Wondering if this could be detonation-- "knocking"? After warming, it disappeared completely. Maybe just need higher octane gas??
-- After starting and running a bit there was a pretty terrible smell, most "like" burning rubber or an electrical fire. No fire or resolution of this. Eventually this TOO went mostly away, but still basically present. Could it be adjustment needed for the main belt variable speed tranny?
-- When I move from neutral into either Lo or HIGH range forward gears, I get gear clashing. I did NOT put foot on brake and read in manual(just NOW) that you are supposed to do so. (I have NOT gotten back out to check and see if this matters. ) OR, could it be part of the drive system is mashed up??! Geez, hope not.
-- There is a big open hole allowing direct sight into the belt transmission on the back right side. This can't be normal, it must require some plastic cover. Right? Any rodent could get right into the transmission!
-- THere appears to be no muffler or spark arrestor unit. This "could " be the cause of some of the smell. . . ?? but that should not smell like burning rubber or electrical smell. . .
SO. That is all.
I sure would appreciate any insight on this issues and finally(!). . . if I was to take this into a local dealer what would you say are the top three issues I should have them address first?
thanks!
-
By kmiller7351
Trying to get running a 550 Colman running but I think head gasket went bad. Do i just replace with new gasket, clean up and replace or is there more to it?
-
By xkatrik
It will run great for a day or so, then it will randomly die, sometimes starting right back up, sometimes not. Other times it just won't start at all for a couple days then fire right up the next time. I have drained the gas, refilled with fresh gas, changed the spark plugs, and replaced the entire air filter. Besides buying a new fuel pump to try, is there anything else someone can suggest.
-
By old fart
Trying to find battery size for 2023 750 eps secter, wqantedd to see if any one had in stock as we live outside of town. Seems like it's a highly gaurded secret.
-
By lfredg
I have a Massimo t-boss 410 in shop will not start with injector installed, have to hold above hole to get to start , if unplug tps it will run if map sensor is out. replaced ecu, map,and injector.
Still no run, pulled the valve out of throttle body it runs high idle to an idle if out a 1/4 inch, still have hold injecter out to start, but with the valve thing out you can install map and injector for it to run. what do I need to do.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.