-
Popular Now
-
-
Similar Topics
-
By johnney
it started bogging down when under acceleration. so first i replaced the carbeurator, no change. now i replaced the wet assembly and no change. what am i missing. is there a sensor or something im missing. HELP, HELP, HELP
-
.thumb.jpg.080f7ba3deabf170051987f7b5514b04.jpg)
By RickinMT
2021 Hisun/Axis 700.
I've had some good trail rides with this thing, on some rough roads, although the last two rides weren't rough at all. ANYWAY, yesterday I pulled out of the garage and it clunked really loud, like the clunk when it's trying to pop out of gear... (I think we've all heard that..) And I'm used to it, in both Hi and Lo, but it seemed louder this time but it still moved. I got it up to the front yard and it clunked a few more times, loudly, and then it refused to move. Engine is fine: just no movement. I towed it back down to the garage and took a look at it today. I suspected the belt and had loosened all the belt cover bolts, but I thought I'd check for movement of the drive shaft. Started it up, set the brake, put it in Lo and gunned it. No-go. Then I noticed the front drive shaft was turning a bit. I pushed the button and put it in 4-wheel and gunned it again and the machine lurched forward a bit. The front drive shaft is turning and it wants to move so I guess it's not the belt. SO SO glad I didn't take the cover off- It's a royal pain to put back on... SO. I'm no mechanic but looking for input from you guys. Any suggestions on what to check next? Thanks in advance. So, searching forums.... The symptoms match what some guys are calling a broken "through shaft." I'm seeing drive shaft, through shaft, middle shaft... What to look for? -
By Ztmartin96
I’m working on a 2011 Bobcat 3400. At around 20mph it bogs down and loses all power. If you let off the gas and let it slow down, it’ll go again until 20mph.
It use to not do this. Use to run 30mph+ no problem. I’ve replaced the fuel injector, fuel pump, spark plug, and air filter. Cleaned the throttle body, the fuel lines, and cleaned the fuel tank out.
What am I missing? Any help would be greatly appreciated.
-
By Mark Armstrong
Hi,
I am in need of a wiring diagram for a 2011 gray wolf 500. I have searched to no end and cannot find one. Nothing comes on when I turn on the ignition switch. Battery is new and the winch works. I did find a blown 30a fuse on the starter relay and thought for sure I found the problem but still nothing comes on after replacing the fuse and the fuse hasn't blown again since replacing it, I have checked every fuse I can find. Bottom line is I am lost and in the blind without a wiring diagram. Any help is greatly appreciated! TIA!!
-
By CRV
I’m need a couple parts. Diff. Lock Actuator mainly. But I would like to find a donor that maybe has bad motor or something along those lines.
if anyone has or knows of anything please holler at me
thanks Randy
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.