Quantcast
Jump to content

Need help converting

Travis

By Travis
in UTV General Discussion

 Share

Recommended Posts

Travis Grand Master

Travis

Posted
Posted (edited)

Going to try to measure the rotor clearences on the oil pump. manual says:

(Use feeler gauge)

 Standard: Less than 0.14 MM

 Service Limit: 0.3 MM

and i cant find a  0.14 mm feeler gauge.

 ?????

i think, if my math is correct it comes out to .005?  5 thou?

Edited by Travis
Solution
Link to comment
Share on other sites
  • 1 month later...
Dan B Community Regular

Dan B

Posted
Posted

I have a 2014 Joyner Renegade with the Chery 1100cc engine.  It appears that the oil pump is driven directly from the crankshaft.  I'm going to try a heavier weight oil (40 or 50) to see if that improves my idle oil pressure (it's at 10 psi, bare minimum).

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Travis
      Kawasaki Mule 550,520,500 Complete service manual
      By Travis
      View File Kawasaki Mule 550,520,500 Complete service manual
      This is a complete service manual for the Kawasaki Mule 500,520 and 550 models.
      Topics  covered include Brakes, Steering, Electrical system, suspension and fuel system. As well as engine repair procedures and Transmission/Final Drive procedures.
       
      ********************************************************************************************************************************************************************************************
      If you need more information about the engine this manual linked below is chock full of information.
      Thanks goes to @cliffyk for getting these files all  into one PDF format for uploading.
      Submitter Travis Submitted 04/18/2021 Category Kawasaki  
    • Smittay
      Opinions on reliability and maintenance
      By Smittay
      Looked at a lot of UTVs lately. Couple Questions about Hisun. Some people say they are just cheap with no customer service. Other people seem to have no problems with them.
      Any opinions on Hisun reliability?
      Heard parts are hard to get. Is that true?
      If you had one and didn't like it what do you recommend?
       
    • Smittay
      Massimo durability and parts
      By Smittay
      (posted a similar question to the Hisun folks) Looked at a lot of UTVs lately. Couple Questions about Massimo. Some people say they are just cheap with no customer service. Other people seem to have no problems with them.
      Any opinions on Massimo durability?
      Heard parts might hard to get. Is that true?
      What models are the best?
      If you had one and didn't like it what do you recommend? 
    • Nathon S.
      Bennche 700 EFI Bighorn New Fuel pump not working
      By Nathon S.
      I have a Bennche 700 EFI Bighorn. I’ve recently been unable to get it to start. After a little troubleshooting I realized my fuel pump was not pumping fuel. This weekend I emptied the gas and replaced it with new. I replaced the fuel pump, fuel filter and fuel injector. I also replaced the battery, spark plug and made sure all my fuses and relays were good. I have confirmed that the float on the fuel pump is not obstructed. The UTV is about 12 years old and has less than 100 hours on it. It has not run in over a year.  Not sure whats going on?!? After doing a little reading I'm leaning towards it being an issue with the ECU or perhaps a faulty wire in the wiring harness. Anyone have any ideas on where to start looking or what I could be dealing with? Any help is appreciated, thanks in advance!
    • JSmojo
      Massimo quality and maintenance
      By JSmojo
      I've been looking at various types of UTVs in the 400-700cc range. It seems that Massimo has a really good price point but I don't know much about their reliability and availability of parts. Been looking specifically at their T-Boss 550. I've heard the parts might be an issue because the network is smaller, but couldn't find much info from owners.
      Here are a few specific questions about them
      1. In your opinion, are the reliable? Specifically, have you hand any parts break that in your mind shouldn't have? 
      2. If you had one and got rid of it, what was the reason? 
      3. If you don't recommend Massimo, what would you recommend (even if it costs a little more)?
      4. How easy is it to find a place to service them? How easy is it to get parts if you want to service it yourself? 
      If you have any other advice, I would appreciate it. I'm also looking at the Hisun Sector 550.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...