Quantcast
Jump to content


Recommended Posts

Posted

First, understand that my T-boss 410 doesn't move very often, since I don't yet have a trailer and no trails nearby. So I occasionally go out and start it, let it idle, and take a ride around my property. This time, the battery was all but dead, so I put it on a charger. It showed a full charge after a few hours, so I reinstalled it in the UTV, and attempted to start it again. It acted as though it was almost dead, as before. I hooked up the charger and jump started it, which took several tries. It's the stock battery, but the unit only has 14.5 hours on it. I purchased it in an auction on Ebay back in December of last year. It was a floor model. Everything seems in good working order. Could I have a bad cell in the battery? How can I test for that?

Thanks!

Posted

Do you have a multimeter? if so

Set it DC 20 volts, attach the leads to  + and -, take note of the voltage, turn the key to START, take note of the voltage, if it drops below about 10.5 volts, 99% of the time bad battery. Auto parts stores like O'rielly's will load test batteries for FREE.

Posted

Thanks, I will try that. I am aware of the auto parts stores testing a battery for free, I am just trying to avoid going out as much as possible. The COVID 19 infection here is really high currently. I also feel sort of beholding to the parts store to purchase a new battery there. 

This battery is a 335CCA unit. I would think it would spin the motor easily. 

Posted

I was thinking the same thing. I'm trying to research a way to rejuvenate the cell, or if I can't do that, then renew the battery. I see plenty of ways on the internet, but some seem so outrageous that I just stopped searching, at least for the time being. 

Would a battery for a lawn tractor work? They seem to be much more affordable than one specific to powersports. 

Posted
5 hours ago, T-boss 410 said:

I was thinking the same thing. I'm trying to research a way to rejuvenate the cell, or if I can't do that, then renew the battery. I see plenty of ways on the internet, but some seem so outrageous that I just stopped searching, at least for the time being. 

Would a battery for a lawn tractor work? They seem to be much more affordable than one specific to powersports. 

as long as you get the correct CCA i don't see why not.

Posted
On 11/11/2020 at 5:46 PM, T-boss 410 said:

Thanks, I will try that. I am aware of the auto parts stores testing a battery for free, I am just trying to avoid going out as much as possible. The COVID 19 infection here is really high currently. I also feel sort of beholding to the parts store to purchase a new battery there. 

This battery is a 335CCA unit. I would think it would spin the motor easily. 

I ordered a battery of the right size and amps from Amazon. It is more likely you have a battery with a bad cell, one of these gave me a problem for two days, it caused me to tear down the body to get to the starter because my new tech battery charger gave a full battery reading but the starter acted like it was dragging. I had checked the battery for voltage with a multimeter, but finally hooked it up to a battery tester (One that can add a heavy load).  It showed under load only 6 volts. A new battery fixed the problem.

Posted

A Harbor Freight battery tester probably costs less than a 40 mile trip to WallyWorld (that is how far I am from a big town with a wallyWorld or a McDonalds.  Out here in the Boonies the RFD mail carrier delivers what Fedex or UPS don't. Then you don't have to wonder about that battery.

I have this one from Amazon

61feCaOWBfL._AC_SL1100_.jpg
Battery Load Tester and Voltmeter"> Schumacher BT-100 100A Battery Load Tester and Voltmeter
Posted

Well, hooked up a load tester. It showed 12 volts before the load was applied. Once I applied the load, the needle fell almost as fast as it would if I was disconnecting the tester. Fell like a rock! Guess I'm in need of a new battery!

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Tim n Deb
      Riding out today it acted like it ran out of gas,  stalled and died and would not start.   Towed back to house,  New  plug added this past month,  plenty of oil, getting plenty of gas, battery cranks good.   Trys to kick in and starts but doesnt.   Two days prior while sitting at a idle it died.  Added gas and it started did my ranch chores with it.  But just now it stalled out cranks but will not start.   Tried to find if fault codes came up on the clock like manual says but not sure I am doing that right.  Any and all help apprecated.  Thank you
    • By KWinTX
      I just bought a new 2024 Hison 550 Stryker 2 months ago. this is the second time I have had this issue.  It only has about 20 hours on it. The last time it happened we took it back to the dealer. it was a fuse.  Since we live three-hour time driving there and back. I would like to find another solution if possible.  I have tried all the fuses that seem to have anything to do with starting.  Currently checking the battery. The battery is new. it came with the unit. It is probably 6 months old.  the UTV has all power to everything electrical. lights turn signals and radio all work.  When trying the key to start . it is 100% dead. as in it doesn't even click.  There is a low whirring like the fuel pump is turning on though. The Unit was running and driving just fine.  we shut it down for the night. The next morning my wife found it in this condition.  Thanks for any Ideas or solutions???   Otherwise, it goes back to the dealer tomorrow. Just hope I didn't buy a lemon. Great little UTV when it does run.😅  anyone else ever have this Issue..? 
    • By Homeowner A
      What's the best replacement battery option for a Coleman UTV 400?  
    • By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!
    • By Hunterman22
      2021 Hisun Axis 500 UTV (From Lowes)
      Will NOT START
      MY apologies if this is to much info just wanted to give yal the most information possible for help.
      I'm a so called diyer. An Electrician by trade 21yrs. I got my S×S from my last job. The contractor purchased this S×S for this specific job brand new, from Lowes. They used it for hauling materials, tools, & a little bit of anything you can think of on an Industrial type job site. 
      I remember getting on the SxS one time & pushed the gas petal all the way to the floor & SxS had very little power. 
      So anyway ,when the job finished up back mid July this year (7/2024) , I asked the contractor what they was going to do with it. I was told to take it. Otherwise it would go to the contractors yard (storage yard) & most likely rust away. 
      Took it home washed it , it had a heavy coat of dust on it & in it dust was every where. My helper & I had to push it on the trailer to get it home.  After washing it throughly I let it sit & dry out for a good day and half, maybe 2 days. Before trying to start it. NO START. Will turn over & try to start but thats it. 
      So here's what I've purchased & installed. New Air Filter, new spark plug, new air idle control valve (AICV), new throttle position sensor, new throttle body, new oxygen sensor, new digital dash speedometer/fuel gauge/clock. 
      Also drained the old oil & gas & replaced with new oil & 93oct. gas. I should probably mention that I've changed the AICV twice. The 1st time I changed the AICV I was able to get the SxS started & let idle for at least 10-15min. Drove out of the garage, with very little power,  turned it around & barely got it back in the garage.That was the one & only time I've been able to start the SxS. I've also cleaned the Throttle Body and & intake with TB cleaner.  So after that the AICV was  making weird noise so I pulled it out & tried cleaning it, pretty sure I messed it up. So I purchased a Throttle Body that came with new AICV & TPS. Still NO START.  I've checked the fuel pump & the fuel injector.  I took the injector off still hooked up to wiring & turned the key over, the injector sprayed a lot of gas out kinda the size of a volleyball. I've also checked the clearance gap on the intake & exhaust valve. But today 11/2/2024 I'm going recheck spark plug gap & the valve gaps. And alot of other checking. Would the driver side seat belt have anything to do with it not starting?? I know the driver side seat belt has to be in gauged for full throttle "going fast". Thing is the drv. side seat belt will latch but feels like might be messed up inside of it. Tired opening it up but to no avail.  I've never had a S×S or 4wheeler so I was really excited when I got the S×S,not so much anymore.  I work on & fix my own vehicles usually no problems.  But this SxS is kicking my ass.
      So if possible & someone could help me with some ideas or tell me what Im doing wrong or did wrong, I would greatly appreciate it.  Thank you for reading thus far.
       
       
×
×
  • Create New...