Quantcast
Jump to content


Recommended Posts

Posted

all depends on the problem

Only if you have problems after it sits for a week or so.

if you run it for a hour or so a day like mine, no problems.

 Star Tron also does very well at preventing carbs from gumming etc.  I've cleaned too many carbs where the Sta Bil apparently fell out of suspension and gets sucked into the carburetor all at once.. doesn't run too well on only stabil.

 

 

 

  • Like 1
  • 11 months later...
Posted
On 8/31/2021 at 7:17 PM, Travis said:

all depends on the problem

Only if you have problems after it sits for a week or so.

if you run it for a hour or so a day like mine, no problems.

 Star Tron also does very well at preventing carbs from gumming etc.  I've cleaned too many carbs where the Sta Bil apparently fell out of suspension and gets sucked into the carburetor all at once.. doesn't run too well on only stabil.

 

 

 

Almost a yr later but I never buy Non-ethanol. But I do use Star-Tron. Your gas will NOT go bad if you add Star-Tron....unless you get water and water never did workload with gas. My portable generator has 2 yr old gas in it......with Star-Tron.  Started it a few weeks ago, ran it for half an hr, ran great.

  • Like 2
Posted
2 hours ago, Don W said:

Almost a yr later but I never buy Non-ethanol. But I do use Star-Tron. Your gas will NOT go bad if you add Star-Tron....unless you get water and water never did workload with gas. My portable generator has 2 yr old gas in it......with Star-Tron.  Started it a few weeks ago, ran it for half an hr, ran great.

good to hear!

 

  • 1 year later...
  • 3 weeks later...
  • 2 years later...
Posted
On 8/31/2021 at 2:17 PM, WhiteLightning said:

It's all I use. Only thing I put in my mowers, too.

You’re lucky you have a station that sells it nearby. In AZ tiara aren’t any stations that sell it within 60 miles of Phenix.

  • Like 1
Posted
10 hours ago, Fritz GSD said:

You’re lucky you have a station that sells it nearby. In AZ tiara aren’t any stations that sell it within 60 miles of Phenix.

Lucky for you, AZ has little humidity and lots of sun!

Moisture is the root of the problems that stem from ethanol fuel.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By AaronD1982
      Next problem with charging system to tackle, any help would be appreciated.
      New starter solenoid....check
      New Voltage Regulator...check.
      Dynamic test to Stator.....bang...pulling like 2 Volts AC
      Problem: Without pulling the part out and stranding the vehicle at the shop forever.... I am trying to find the correct stator or at least one that might not be exact for the Massimo Buck 400S, but fit and connect and do the job if that makes sense.... if anyone has any ideas, please shoot them my way.
    • By AaronD1982
      I recently purchased a 2019 or 2020 (no manual) Massimo 400S Buck Series UTV.  It ran fine for a couple days but the low battery light was flashing while it drove.  It then died in the field one day and I was able to jump the battery and get it rolling enough to get back to the barn.  It started both times I turned the key for a couple days after and when driven died 10 minutes later in the driveway.  Even after jumping it had no juice, but with the key out of the ignition it kept trying to start, a quick look on the Google machine and it suggested starter solenoid or ignition switch was the culprit.  Fair enough, let's just order a replacement solenoid, right?  No way Jose....the pin connector on the UTV is a 2-pin white plastic connector and the part received is a 4 pin.  How do I swap that and make it work?  Can I even?  Where do I find correct parts in the future?
    • By Eman85
      I have been searching and can't find much info on these units. Pretty surprising as every other thing I own I find a lot of info on. Researching for tech info and such it's like no one owns any of these yet I see them everywhere. 
    • By Jeff freeman
      I have a Coleman 550.  Was having problems to start with where it would start and then shut off after a couple tries. It would take off and be good. It then got to a point where it would not start at all. I replaced the fuel injection twice the second time I replaced it I noticed a mouse or something had chewed one of the wires that connect the electrical to the fuel injector. . So two-part question first does anybody have a part number for that wire harness?  Second, any other ideas after I fix the wire harness permanently on what could keep it from starting I have gas flow up to the fuel injector.


×
×
  • Create New...