-
Similar Topics
-
By lincolnsq175
Ive searched and cannot find any performance parts that fit my machine.
I have a 2020 coleman ut400.
Im looking for machined sheave kit, programmers, cdi, exhaust and intake.
I know these are yamaha rhino clones but are they rhino 450 clones?
Any info is appreciated.
-
By John1990
I was taking my family on a little ride up the road going uphill in our massimo msu 500. Then all of a sudden it quit pulling and the rpms went up way high to over 6000. After we got it pushed on up the hill and turned around was able to coast back to the house. We do ride it alot on the main road, so I am assuming top speed and top rpms constantly is more than likely to blame for this issue, now I just need to know how to fix it. If anyone has any suggestions it is appreciated
-
By Joe Breaux
about to pull the trigger on a CF Moto ATV.. everyone seems to like theirs, good reviews .. anyone want to warn me of issues with them ? I like my Hondas but the prices have gone nuts and availability is a joke.. This seems like a good deal
-
By Mike Turner
American SportWorks LM 650 won’t start at times. Starter won’t engage the solenoid just “clicks” much like a weak battery would cause. Battery was replaced and problem went away and then came back. Replaced positive battery terminal. Problem resolved then returned. Replaced negative battery terminal. Problem gone then returned. Replaced the positive and negative battery cable ends. Problem resolved and now returned. The repair lasts for maybe 12 starts, then the solenoid just “clicks” again as it will with a weak battery. So I replaced the ignition switch. Problem solved for a week. With each “fix” the problem is resolved but only temporarily. Does anyone have any suggestions ? To replace the starter is expensive especially if it’s not the problem.
-
By Dan H 965
I bought a project UTV. 2010 Hisun 700. I'm doing a top end rebuild. The prior owner did some shady stuff to this poor thing. It's got a knock and blown head gasket. Piston is gouged and 3/5 bent valves. Standard stuff if you dont know how to take care of your equipment. But while doing disassembly there is a nipple on the back side of the head, just under the exaust rocker arm peep holes. The guy has a rubber hose clamped to it and pinched it off on the other end with a vice grips left undet the seat. I can't find where this is supposed to attach to. The manual shows it capped on the head in the new models and doesnt address it at all on the old models. Any input?
-
-
-
Gallery Images
![render[2].jpg](https://www.utvboard.com/uploads/1266430190/sml_gallery_475_29_20648.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.