Quantcast
Jump to content


Recommended Posts

Posted

I know some of you have put 31" tires on and have had to do some fender well modifications. Wondering if I go to a 30"X10X14 on stock wheels if I will have to do any fender well mods up front. Hoping to be able to just use stock wheels mount the tires and have no issues with it rubbing on the well. I know 28" tires will be fine but hoping to maybe get that extra 1 inch of ride height with a 30". I have a T-4 so I high center at times.

Posted

Yes, ITP Mud Lite XXL in 30X10X14 and 30X12X14 are available. They are expensive but will fit. Just wondering if there will be any problems with fender well and having to do any modifications.

Posted

I have same tires on black ss wheels the front is good I think (have modded fenders) no rubing but you will break the back fenders if you bottom out. Take them off and move them up on top of horizontal pipe right above them and remount and they will be good

Posted

i am running 30" Silverbacks on 14" wheels i had to put 2" wheel spacers up front... now the wheel base width is exactly the same. i love 'em! no fender well trimming.

you can also adjust out the rear himze joints to offset the a-arm foward a little bit

Posted

2scoops has these tires. http://www.superatv....l-P963C709.aspx

They also offer a 28.5

My only warning is that these tires are much heavier than stock, but any 6 ply 30" ATV tire will be. I believe the 30x10x14 were 10lbs heavier a piece per tire than the stock, and the 30x12x14 were 15lbs heavier. That is a siginificant difference mainly due to the stock tires being made of paper mache and recycled road tar. By the time I changed them out the stock tires had more tire plugs and slime in them than air. I added Silverbullets fuel controller and it offset any powerloss and them some.

The benefits:

I can run them at low ATV pressures 5-10psi. This will impove your offroad ride alot. I think the stock tires call for around 30 psi???

I haven't had a flat yet (desert & mountain trail riding)

Traction is awesome in all areas.

The 30" size allows me to roll over much bigger rocks & bumps with ease. This helps me maintain my momentum which is a huge benefit with at stick shift.

The ground clearance with 30" tires is much better.

The price was good.

Most importantly--they look badass

The cons:

They don't balance worth a damn. I had a little steering wheel shimmy before I added the powersteering kit (now there is none).

They wear quickly, but that is inherent of an ATV tire. I think these may wear slightly quicker because the rubber is pretty soft. BUT this is why they stick to the rocks so well.

Off the line acceleration is a slightly slower, but top speed is higher.

Posted

I went with the Vision 15" rims with 30 inch BF Goodrich tires. I just got back today from the Baja 250 and the tires made a big difference for me. Since I have the T-4 also the extra lift is great. I did also add a better fuel pump. I was flying over pieces of the course today having a blast. Now more suspension here I come.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Topics

    • By rdc
      Hope I posted this in the right place. Looking for the left side shaft carrier where the rear bearings go for an 1100cc sand viper, I understand an 800 cc carrier will also work. I need the old style two bearing with the spacer in the middle, the new style with just the one wide bearing wont work. If anybody has one I'll buy it right away. my email is [email protected]
    • By paul allen
      right front axle cv joint boot keeps getting torn up from the inside out....the stock one was damaged from a stick...i have replaced  the axle 4 times with aftermarket axles that fit fine..after 4-5 miles of riding even on grass.the outer boot get torn up from the inside out...all 4 brand new alxes...bearings are fine nothing bent everything fits just fine....nothing seems to be binding.....any thoughts?????
       
       
      thanks...pa
       
    • By MilSurpYinzer
      Hey all, I was just wondering what you guys consider a necessary upgrade or spare part to have or mod onto your machine.
      I'm going for a kind of shtf survival rig that's not going to be SUPER heavy and I'm looking at getting:
      A spare belt (I keep seeing this mentioned everywhere I look so it must be important)
      A spare tire and mount( So would I need a jack like one from an old jeep or something else?)
      Tire chains for the winter
      And maybe a cargo bed upgrade so things don't slide out.
      Bumpers because duh.
      I already installed high output lights and have a windshield, roof, back window, and winch. And I outfitted a Molle panel for the back of my passenger seat with extra supplies like food, first aid, and spare mags.
      Any advise on increasing durability, longevity, and having something on hand because it's absolutely necessary would be a plus.
      Thanks so much!
    • By Sharon
      The center console is not working, anyone know how to fix it? 
    • By KMP
      We just bought our 1st side-by-side and wanted to get tips on maintenance items we should address immediately for our 2015 Arctic Cat Wildcat Sport 700 XT.  We are truly beginners and welcome any and all suggestions.  Thank you, we appreciate your help!
×
×
  • Create New...