Quantcast
Jump to content

New Members Area

Are you a new member to UTVBoard.com? Stop by here and introduce yourself. Tell us about yourself, your vehicle, etc.

167 topics in this forum

    • 1 reply
    • 371 views
  1. New guy

    • 1 reply
    • 284 views
  2. New

    • 2 replies
    • 328 views
    • 3 replies
    • 307 views
  3. New member from Buenos Aires

    • 2 replies
    • 334 views
  4. just saying hi

    • 2 replies
    • 297 views
    • 3 replies
    • 402 views
    • 8 replies
    • 436 views
  5. Newbie

    • 3 replies
    • 419 views
    • 1 reply
    • 420 views
  6. Hello all

    • 1 reply
    • 403 views
    • 10 replies
    • 1,063 views
    • 0 replies
    • 404 views
  7. New member here

    • 69 replies
    • 1,695 views
    • 1 reply
    • 331 views
    • 5 replies
    • 424 views
  8. New Member

    • 0 replies
    • 222 views
  9. New Member from NY.

    • 2 replies
    • 353 views
  10. New from China

    • 4 replies
    • 790 views
  11. New fella PA

    • 3 replies
    • 594 views
  12. new guy

    • 1 reply
    • 523 views
  13. new guy

    • 1 reply
    • 427 views
  14. Newbie from Vegas

    • 0 replies
    • 458 views
    • 0 replies
    • 605 views
    • 0 replies
    • 494 views


  • Latest Posts

    • Stuck float should be easy. locate the carb, take off the bowl, (bowl nut on carb, ) the float should be level, not hanging down.   fuel pump: Pretty much, just replace it. They don't make any repair parts for them.   Found this thread reply on another forum, seems to be a common problem with the 610  a dirty carburetor...or a bad float ...or a bad inlet needle.   What is happening is that the gasoline is bypassing the float needle and is overflowing. Then it goes through this passageways and into the oil pan.   IF there is dirt that has gotten onto the needle or seat, this will hold the needle open.   If there is a small hole in the float, then the float will sink allowing too much gas to enter the carburetor. causing this problem.   If the needle or seat has worn or has a chip in it, then the gas will bypass them and flow into the oil.   This is a very common problem.   ALSO, if you have a vacuum operated fuel pump, the diaphram inside the pump may have gotten a hole in it. This will allow gasoline to pass through the diaphram and into the oil supply.  
    • Don't know if this will help, but it looked interesting, and possibly relevant. If you end up finding that the fuel pump is the problem. I'm not sure what obstacle the poster ran into that made him go this way, instead of an actual repair. But sometimes there's little choice. But until we know what the problem is, this is a cheap alternative, and a quick fix. If it's a stuck float, a fuel cut off is always a good idea anyway. And it'll stop that particular issue. Although it won't actually fix the real problem, it'll stop the unwanted gas.
    • Travis, any advice on how to check for these conditions? I'm not much of a mechanic but a fast learner.
    • Contact me, I have the service manual I can give you 562-682-7859 Matt
    • Is the seatbelt plugged in? It has a limiter if not connected 


×