Hisun UTV SxS Forum
This is for all of you Hisun UTV, SxS (Side by Side) owners. Discussions about Hisun UTV specific topics including Sector, Strike, and HS models.
489 topics in this forum
-
- 6 replies
- 638 views
-
- 11 replies
- 565 views
-
- 7 replies
- 910 views
-
- 8 replies
- 464 views
-
- 4 replies
- 4.9k views
-
- 4 replies
- 607 views
-
- 0 replies
- 369 views
-
- 8 replies
- 4.1k views
-
- 2 replies
- 551 views
-
- 3 replies
- 401 views
-
- 4 replies
- 399 views
-
- 4 replies
- 473 views
-
- 2 replies
- 383 views
-
- 17 replies
- 14.1k views
-
- 3 replies
- 629 views
-
- 2 replies
- 325 views
-
- 12 replies
- 9.1k views
-
- 16 replies
- 9.7k views
-
- 2 replies
- 553 views
-
- 0 replies
- 301 views
-
- 3 replies
- 3.3k views
-
- 5 replies
- 3k views
-
- 4 replies
- 618 views
-
- 2 replies
- 637 views
-
- 3 replies
- 549 views
-
- 1 reply
- 606 views
-
- 0 replies
- 6.8k views
-
- 0 replies
- 575 views
-
- 0 replies
- 670 views
-
- 9 replies
- 6.5k views
-
Latest Posts
-
By Greg Kilgore · Posted
Couldn't tell a lot from video. Did sound like a little bit of a miss. In the dark check to see if the plug wire is arcing. Check connections for coil and spark plug. Maybe check and re-gap the spark plug. Good luck and keep us informed. -
I'm having a similar issue with my Axis 500. It seems to bog down and struggle, particularly on inclines/hills (see video). Frustratingly, it also only happens intermittently, more often when the machine has been running for a while (I use it for farm work only). So far I have: Replaced fuel filter Replaced fuel injector Replaced MAP sensor (reset ECU after) Replaced spark plug Verified air filter is clean Verified no obstructions in exhaust I only run it on 91+ gas and put a can of seafoam through it to no avail I did previously have an issue with a failed one-way bearing, but this particular issue predates that failure. I replaced the one-way bearing a few months ago and inspected the wet clutch, primary/secondary clutches and belt while I was in there-didn't see anything of concern. Where do I go from here? IMG_9433.MOV -
By dave pasch · Posted
Got it running. The 4wd gets 12v power but does not engage. The posi traction (rear end) does not engage also. Any one have experience / ideas on fixing these items? Thanks Dave -
I don't know anything about the atvs, but he you tried shorting the solenoid with a screwdriver, and if so does it crank over or start? -
By Clyde says · Posted
Thanks for the info. I did locate the part on partstree and it was very expensive $291.00 plus tax and shipping total $325. The part wasn't much bigger than a quarter. I'll try and include a Pic. Anyway I installed it and the UTV runs well. Yes it is gas not propane. I switched to non-ethonal gas.
-
