Quantcast
Jump to content

UTV General Discussion

UTV Side by Side General Discussions Forum. Please post UTV related topics in this forum only.

233 topics in this forum

  1. IRONMAN

    • 0 replies
    • 1,065 views
    • 1 reply
    • 873 views
  2. Building My Own

    • 3 replies
    • 1,640 views
    • 0 replies
    • 821 views
  3. Wiring Problems

    • 0 replies
    • 1,771 views
    • 0 replies
    • 1,536 views
    • 1 reply
    • 1,916 views
    • 0 replies
    • 746 views
  4. Mountaineer 800TXE

    • 1 reply
    • 4,622 views
    • 4 replies
    • 1,601 views
    • 6 replies
    • 7,755 views
    • 0 replies
    • 890 views
    • 0 replies
    • 567 views
    • 3 replies
    • 1,149 views
    • 1 reply
    • 1,369 views
    • 0 replies
    • 678 views
    • 0 replies
    • 639 views
    • 2 replies
    • 1,443 views
  5. My new Drakart

    • 6 replies
    • 2,030 views
    • 9 replies
    • 5,895 views
  6. Ride hieght

    • 2 replies
    • 860 views
  7. Finally a snow ride

    • 0 replies
    • 651 views
  8. diesel utv

    • 5 replies
    • 2,017 views
  9. Local Utah site?

    • 7 replies
    • 1,370 views
    • 0 replies
    • 908 views


  • Latest Posts

    • Stuck float should be easy. locate the carb, take off the bowl, (bowl nut on carb, ) the float should be level, not hanging down.   fuel pump: Pretty much, just replace it. They don't make any repair parts for them.   Found this thread reply on another forum, seems to be a common problem with the 610  a dirty carburetor...or a bad float ...or a bad inlet needle.   What is happening is that the gasoline is bypassing the float needle and is overflowing. Then it goes through this passageways and into the oil pan.   IF there is dirt that has gotten onto the needle or seat, this will hold the needle open.   If there is a small hole in the float, then the float will sink allowing too much gas to enter the carburetor. causing this problem.   If the needle or seat has worn or has a chip in it, then the gas will bypass them and flow into the oil.   This is a very common problem.   ALSO, if you have a vacuum operated fuel pump, the diaphram inside the pump may have gotten a hole in it. This will allow gasoline to pass through the diaphram and into the oil supply.  
    • Don't know if this will help, but it looked interesting, and possibly relevant. If you end up finding that the fuel pump is the problem. I'm not sure what obstacle the poster ran into that made him go this way, instead of an actual repair. But sometimes there's little choice. But until we know what the problem is, this is a cheap alternative, and a quick fix. If it's a stuck float, a fuel cut off is always a good idea anyway. And it'll stop that particular issue. Although it won't actually fix the real problem, it'll stop the unwanted gas.
    • Travis, any advice on how to check for these conditions? I'm not much of a mechanic but a fast learner.
    • Contact me, I have the service manual I can give you 562-682-7859 Matt
    • Is the seatbelt plugged in? It has a limiter if not connected 


×