Quantcast
Jump to content

Joyner UTV SxS Forum

This is for all of you Joyner Trooper, Commando, and Renegade UTV owners. Joyner UTV specific topics.

1,600 topics in this forum

    • 28 replies
    • 67,360 views
    • 8 replies
    • 8,248 views
  1. Unique Fixes

    • 13 replies
    • 11,665 views
    • 10 replies
    • 13,486 views
    • 11 replies
    • 2,697 views
    • 0 replies
    • 79 views
    • 5 replies
    • 96 views
    • 23 replies
    • 1,693 views
    • 20 replies
    • 408 views
    • 16 replies
    • 255 views
    • 3 replies
    • 162 views
    • 8 replies
    • 244 views
    • 0 replies
    • 104 views
    • 3 replies
    • 138 views
    • 10 replies
    • 1,874 views
    • 30 replies
    • 1,230 views
    • 8 replies
    • 474 views
    • 3 replies
    • 139 views
  2. Fuel Controller

    • 69 replies
    • 16,779 views
    • 3 replies
    • 394 views
    • 9 replies
    • 495 views
    • 0 replies
    • 126 views
    • 5 replies
    • 171 views
  3. Piggyback ecu on trooper?

    • 0 replies
    • 173 views
    • 15 replies
    • 795 views


  • Latest Posts

    • I have a Joyner cammando 650cc but I need a spiral bevel gear rear and pinion. I'm unable to locate any. Mine is stripped and only front wheel pull¬† do you know where I can get one?
    • Glad to see theres some more out there when i was looking for mine it seemed like it was a hard to come by item, joyner told me the one i bought was the only one they had left.
    • The YouTube video says the top of line configuration for this ride is about $62,000.
    • UPDATE: I've been so dang busy lately, i finally got a couple of hours to work on the jacka$$... i mean Mule..ūüėČ Got the rod bolts torqued, pulled off the oil pump/tang installed the cam and timed it it to the crank, put the cover on, and for those who dont know or remember the ordeal with the crankshaft and cover: There is a¬† shim between the crankcase cover and the crankgear, this helps control the end play, or side to side movement of the crank. anyway, the first time i installed the cover the crankshaft would not spin by hand (according to the manual its supposed too)¬† so i measure all the clearances¬† (according to the manual instructions) and came up with the correct size shim. so back to TODAY. ¬†I installed the new¬† shim (VERY easy)¬† slid the cover on, put the new bolts in, torqued them and the moment of truth,¬† the crankshaft spun by hand,which is what i was looking for! ¬†So now all i need to do¬† is install the head and set the valve clearance. and for anyone else rebuilding any engine,¬† i do not recommend using Permatex¬† assembly lube, it is¬† very slick and not tacky, it runs of the parts easily, so i bought some Lucas lube, and it's slick, but tacky enough it held onto the¬† surfaces. https://www.amazon.com/Lucas-Oil-10152-Assembly-Lube/dp/B000WJ3M6I ¬†


√ó