Massimo UTV SxS Forum
This is for all of you Massimo UTV, SxS (Side by Side) owners. Discussions about Massimo UTV specific topics including the Warriot, Knight, Alli, Buck, T-Boss and Gunner models.
358 topics in this forum
-
- 43 replies
- 52.3k views
-
- 18 replies
- 640 views
-
- 2 replies
- 1.8k views
-
- 10 replies
- 506 views
-
- 1 reply
- 219 views
-
- 0 replies
- 125 views
-
- 43 replies
- 16k views
-
- 8 replies
- 4k views
-
- 3 replies
- 247 views
-
- 16 replies
- 1.2k views
-
- 6 replies
- 797 views
-
- 1 reply
- 260 views
-
- 1 reply
- 307 views
-
- 1 reply
- 1.5k views
-
- 7 replies
- 9.7k views
-
- 9 replies
- 2.9k views
-
- 4 replies
- 530 views
-
- 0 replies
- 831 views
-
- 9 replies
- 1.1k views
-
- 10 replies
- 5.5k views
-
- 0 replies
- 397 views
-
- 1 reply
- 543 views
-
- 2 replies
- 579 views
-
- 9 replies
- 863 views
-
- 7 replies
- 486 views
-
- 7 replies
- 864 views
-
- 3 replies
- 3.5k views
-
- 4 replies
- 756 views
-
- 8 replies
- 1.4k views
-
- 3 replies
- 1.9k views
-
Latest Posts
-
By Greg Kilgore · Posted
Couldn't tell a lot from video. Did sound like a little bit of a miss. In the dark check to see if the plug wire is arcing. Check connections for coil and spark plug. Maybe check and re-gap the spark plug. Good luck and keep us informed. -
I'm having a similar issue with my Axis 500. It seems to bog down and struggle, particularly on inclines/hills (see video). Frustratingly, it also only happens intermittently, more often when the machine has been running for a while (I use it for farm work only). So far I have: Replaced fuel filter Replaced fuel injector Replaced MAP sensor (reset ECU after) Replaced spark plug Verified air filter is clean Verified no obstructions in exhaust I only run it on 91+ gas and put a can of seafoam through it to no avail I did previously have an issue with a failed one-way bearing, but this particular issue predates that failure. I replaced the one-way bearing a few months ago and inspected the wet clutch, primary/secondary clutches and belt while I was in there-didn't see anything of concern. Where do I go from here? IMG_9433.MOV -
By dave pasch · Posted
Got it running. The 4wd gets 12v power but does not engage. The posi traction (rear end) does not engage also. Any one have experience / ideas on fixing these items? Thanks Dave -
I don't know anything about the atvs, but he you tried shorting the solenoid with a screwdriver, and if so does it crank over or start? -
By Clyde says · Posted
Thanks for the info. I did locate the part on partstree and it was very expensive $291.00 plus tax and shipping total $325. The part wasn't much bigger than a quarter. I'll try and include a Pic. Anyway I installed it and the UTV runs well. Yes it is gas not propane. I switched to non-ethonal gas.
-
